Comparison of efficiency and stability maps obtained by various methods
- 10 December 2017
- journal article
- research article
- Published by Taylor & Francis in Advances in Materials and Processing Technologies
- Vol. 4 (1) , 132-141
Abstract
One of the most widely accepted tools for the identification of the optimum processing conditions for hot-working is the Dynamic Material Model, whose final aim is the representation of efficiency and stability maps. In the present work, a revision of various stability criteria and calculation of efficiency is conducted and the equations of Ziegler, as revised by Kumar and Prasad, and Lyapunov as revised by Malas and Gegel and Prasad are established. Determination of the strain rate sensitivity exponent, m is essential to establish the stability regions. This parameter is usually determined by fitting the curves strain rate, , vs. stress, σ, by means of a potential equation named ‘power law’ or by a polynomial of second or third degree, and calculating the slope of the logarithmic curve at each point using successive derivatives. Furthermore, we introduce our method where all experimental points are fitted to a single hyperbolic sine equation of Garofalo type and then m is calculated for each and T using this equation. An analysis of the maps that are obtained based on various methods and models to compare the predictions with experimental results on different materials is performed.Keywords
Funding Information
- CICYT, Spain (MAT2012-38962)
This publication has 8 references indexed in Scilit:
- Processing maps for hot working of ZK60 magnesium alloyMaterials Science and Engineering: A, 2007
- Processing maps and rate controlling mechanisms of hot deformation of electrolytic tough pitch copper in the temperature range 300–950°CMaterials Science and Engineering: A, 2005
- Validation of processing maps for a 15Cr–15Ni–2.2Mo–0.3Ti austenitic stainless steel using hot forging and rolling testsJournal of Materials Processing Technology, 2003
- Integral method from initial values to obtain the best fit of the Garofalo's creep equationJournal of Materials Processing Technology, 1998
- Propuesta de un método de ordenador para resolver el ajuste a la ecuación de Zener-Hollomon (Garofalo)Revista de Metalurgia, 1996
- Using material behavior models to develop process control strategiesJOM, 1992
- Mapping Dynamic Material Behaviour1989
- Modeling of dynamic material behavior in hot deformation: Forging of Ti-6242Metallurgical Transactions A, 1984