Development of an instrumented thoracoscopic surgical trainer for objective evaluation of esophageal atresia/tracheoesophageal fistula repair
- 11 January 2020
- journal article
- research article
- Published by Springer Nature in Medical & Biological Engineering & Computing
- Vol. 58 (3) , 601-609
Abstract
Operative repair of complex conditions such as esophageal atresia and tracheoesophageal fistula (EA/TEF) is technically demanding, but few training opportunities exist outside the operating theater for surgeons to attain these skills. Learning them during surgery on actual neonates where the stakes are high, margins for error narrow, and where outcomes are influenced by technical expertise, is problematic. There is an increasing demand for high-fidelity simulation that can objectively measure performance. We developed such a simulator to measure force and motion reliably, allowing quantitative feedback of technical skill. A 3D-printed simulator for thoracoscopic repair of EA/TEF was instrumented with motion and force tracking components. A 3D mouse, inertial measurement unit (IMU), and optical sensor that captured force and motion data in four degrees of freedom (DOF) were calibrated and verified for accuracy. The 3D mouse had low average relative errors of 2.81%, 3.15%, and 6.15% for 0 mm, 10 mm offset in Y, and 10 mm offset in X, respectively. This increased to − 23.5% at an offset of 42 mm. The optical sensors and IMU displayed high precision and accuracy with low SDs and average relative errors, respectively. These parameters can be a useful measurement of performance for thoracoscopic EA/TEF simulation prior to surgery. Inclusion of sensors into a high-fidelity simulator design can produce quantitative feedback which can be used to objectively asses performance of a technically difficult procedure. As a result, more surgical training can be done prior to operating on actual patients in the operating theater.Keywords
Funding Information
- Canterbury District Health Board
This publication has 16 references indexed in Scilit:
- Development of an Open-Source Laparoscopic Simulator Capable of Motion and Force Assessment: High Tech at Low CostJournal of Laparoendoscopic & Advanced Surgical Techniques, 2018
- Advances in Pediatric Surgical Education: A Critical Appraisal of Two Consecutive Minimally Invasive Pediatric Surgery Training CoursesJournal of Laparoendoscopic & Advanced Surgical Techniques, 2016
- Motion Analysis–Based Skills Training and Assessment in Pediatric Laparoscopy: Construct, Concurrent, and Content Validity for the eoSim SimulatorJournal of Laparoendoscopic & Advanced Surgical Techniques, 2015
- Quantitative pediatric surgical skill assessment using a rapid-prototyped chest modelMinimally Invasive Therapy & Allied Technologies, 2014
- Influence of visual force feedback on tissue handling in minimally invasive surgeryBritish Journal of Surgery, 2014
- Motion analysis in the pediatric laparoscopic surgery (PLS) simulator: validation and potential use in teaching and assessing surgical skillsJournal of Pediatric Surgery, 2014
- The Role of Haptic Feedback in Laparoscopic Training Using the LapMentor IIJournal of Endourology, 2010
- A Systematic Review of Skills Transfer After Surgical Simulation TrainingAnnals of Surgery, 2008
- Thoracoscopic Repair of Esophageal Atresia and Tracheoesophageal FistulaAnnals of Surgery, 2005
- Construct validation of the ProMIS simulator using a novel laparoscopic suturing taskSurgical Endoscopy, 2005