Finite element analysis performed on radius and tibia HR-pQCT images and fragility fractures at all sites in men
Open Access
- 23 November 2010
- journal article
- research article
- Published by Oxford University Press (OUP) in Journal of Bone and Mineral Research
- Vol. 26 (5) , 965-973
Abstract
Few studies have investigated bone microarchitecture and biomechanical properties in men. This study assessed in vivo both aspects in a population of 185 men (aged 71 ± 10 years) with prevalent fragility fractures, compared to 185 controls matched for age, height, and weight, from the Structure of the Aging Men's Bones (STRAMBO) cohort. In this case-control study, areal BMD (aBMD) was measured by DXA, bone microarchitecture was assessed by high resolution (HR)-pQCT, and finite element (µFE) analysis was based on HR-pQCT images of distal radius and tibia. A principal component (PC) analysis (PCA) was used to study the association of synthetic PCs with fracture by computing their odds ratio (OR [95%CI]) per SD change. Specific associations with vertebral fracture (n = 100), and nonvertebral fracture (n = 85) were also computed. At both sites, areal and volumetric BMD, cortical thickness and trabecular number, separation, and distribution were significantly worse in cases than in controls, with differences ranging from −6% to 15%. µFE-derived stiffness and failure load were 8% to 9% lower in fractures (p < .01). No difference in load distribution was found between the two groups. After adjustment for aBMD, only differences of µFE-derived stresses, stiffness, and failure load at the tibia remained significant (p < .05). PCA resulted in defining 4 independent PCs, explaining 83% of the total variability of bone characteristics. Nonvertebral fractures were associated with PC1, reflecting bone quantity and strength at the radius (tibia) with OR = 1.64 [1.27–2.12] (2.21 [1.60–3.04]), and with PC2, defined by trabecular microarchitecture, with OR = 1.27 [1.00–1.61]. Severe vertebral fractures were associated with PC1, with OR = 1.56 [1.16–2.09] (2.21 [1.59–3.07]), and with PC2, with OR = 1.55 [1.17–2.06] (1.45 [1.06–1.98]). In conclusion, microarchitecture and biomechanical properties derived from µFE were associated with all types of fractures in men, showing that radius and tibia mechanical properties were relatively representative of distant bone site properties. © 2011 American Society for Bone and Mineral Research.Keywords
This publication has 33 references indexed in Scilit:
- Severity of Vertebral Fractures Is Associated With Alterations of Cortical Architecture in Postmenopausal WomenJournal of Bone and Mineral Research, 2009
- Finite Element Analysis of the Proximal Femur and Hip Fracture Risk in Older MenJournal of Bone and Mineral Research, 2009
- High-Resolution pQCT Analysis at the Distal Radius and Tibia Discriminates Patients With Recent Wrist and Femoral Neck FracturesJournal of Bone and Mineral Research, 2008
- Finite Element Analysis Based on In Vivo HR-pQCT Images of the Distal Radius Is Associated With Wrist Fracture in Postmenopausal WomenJournal of Bone and Mineral Research, 2008
- Structural Determinants of Vertebral Fracture RiskJournal of Bone and Mineral Research, 2007
- Accuracy of high-resolution peripheral quantitative computed tomography for measurement of bone qualityMedical Engineering & Physics, 2007
- Contribution of In Vivo Structural Measurements and Load/Strength Ratios to the Determination of Forearm Fracture Risk in Postmenopausal WomenJournal of Bone and Mineral Research, 2007
- Advanced imaging of bone macro and micro structureBone, 1999
- Hip fractures in the elderly: A world-wide projectionOsteoporosis International, 1992
- The Microanatomy of Trabecular Bone Loss in Normal Aging Men and WomenClinical Orthopaedics and Related Research, 1987