Effects of Al3(Sc,Zr) and Shear Band Formation on the Tensile Properties and Fracture Behavior of Al-Mg-Sc-Zr Alloy
- 22 October 2015
- journal article
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 24 (11) , 4244-4252
Abstract
No abstract availableKeywords
This publication has 26 references indexed in Scilit:
- Microstructure and mechanical properties of Al-5.8Mg-Mn-Sc-Zr alloy after annealing treatmentJournal of Central South University, 2012
- Microstructure, tensile strength and wear behaviour of Al–Sc alloyMaterials Science and Engineering: A, 2004
- High strain rate superplasticity in a commercial Al–Mg–Sc alloyScripta Materialia, 2004
- Microstructural evolution in adiabatic shear localization in stainless steelActa Materialia, 2003
- The effect of scandium on the microstructure, mechanical properties and weldability of a cast Al–Mg alloyActa Materialia, 2002
- New Al–Mg–Sc alloysMaterials Science and Engineering: A, 2000
- Investigation of the Nucleation of Recrystallization in an Al-Cu Single Crystal by Means of EBSPMaterials Science Forum, 1993
- Texture development in Al 1.8wt% Cu depending on the precipitation state—I. Rolling texturesActa Metallurgica, 1989
- Microstructure and shear band formation in rolled single crystals of AlMg alloyActa Metallurgica, 1987
- Microscopic versus macroscopic aspect of shear bands deformationActa Metallurgica, 1986