Modelling the performance of a continuously variable supercharger drive system
- 11 July 2011
- journal article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 225 (10) , 1399-1414
Abstract
This paper details a simulation-based investigation into a novel forced-induction boosting system with a centrifugal-type supercharger driven from the engine crankshaft via a continuously variable transmission (CVT). This system acts as a pre-boost to a traditional fixed-geometry turbocharger and has been identified as a possible solution to improving the low-speed engine torque and transient response of future downsized and existing turbocharged engines. The concept was modelled around an existing baseline high-speed direct-injection diesel engine model featuring a variable-geometry turbocharger. Conclusions are drawn comparing the potential of the proposed system with the baseline engine in terms of the brake specific fuel consumption, and both the steady state and the transient performance. A design-of-experiments approach is applied to investigate the effects of the supercharger compressor size, the turbocharger compressor and turbine size, the CVT ratio, and the engine compression ratio on the system performance. Optimization techniques are then applied to identify the best settings for these parameters in the proposed system. Transient simulation was undertaken in a MATLAB/Simulink Ricardo WAVE co-simulation environment to develop the required control strategies for the CVT supercharger. The proposed system demonstrates a significant improvement in the low-speed engine torque and transient response of the boosting system during tip-in pedal events, which it is proposed will result in a significant improvement in the vehicle performance and driveability.Keywords
This publication has 13 references indexed in Scilit:
- Potential to Improve Specific Power Using Very High Injection Pressure In HSDI Diesel EnginesSAE International Journal of Advances and Current Practices in Mobility, 2009
- A New 3 Cylinder 1.2l Advanced Downsizing Technology Demonstrator EngineSAE International Journal of Advances and Current Practices in Mobility, 2008
- A Multiple Factor Simulation and Emulation Approach to Investigate Advanced Air Handling Systems for Future Diesel EnginesSAE International Journal of Advances and Current Practices in Mobility, 2008
- Dynamic Modeling of the Milner Continuously Variable Transmission—The Basic KinematicsJournal of Mechanical Design, 2006
- The Potential of Electric Exhaust Gas Turbocharging for HD Diesel EnginesSAE International Journal of Advances and Current Practices in Mobility, 2006
- CVT Rolling Traction Drives—A Review of Research Into Their Design, Functionality, and ModelingJournal of Mechanical Design, 2005
- Developing the Durability of a Dual-Cavity Full-Toroidal IVT VariatorSAE International Journal of Advances and Current Practices in Mobility, 2002
- Performance Investigations of a Novel Rolling Traction CVTSAE International Journal of Advances and Current Practices in Mobility, 2001
- Supercharging Compressors-Problems and Potential of the Various AlternativesSAE International Journal of Advances and Current Practices in Mobility, 1984
- Turbocharging the Internal Combustion Engine1982