System Identification of a MEMS Gyroscope
Authors:
- 1 June 1999
- journal article
- Published by ASME International in Journal of Dynamic Systems, Measurement, and Control
- Vol. 123 (2) , 201-210
Abstract
This paper reports the experimental system identification of the Jet Propulsion Laboratory MEMS vibratory rate gyroscope. A primary objective is to estimate the orientation of the stiffness matrix principal axes for important sensor dynamic modes with respect to the electrode pick-offs in the sensor. An adaptive lattice filter is initially used to identify a high-order two-input/two-output transfer function describing the input/output dynamics of the sensor. A three-mode model is then developed from the identified input/output model to determine the axes’ orientation. The identified model, which is extracted from only two seconds of input/output data, also yields the frequency split between the sensor’s modes that are exploited in detecting the rotation rate. The principal axes’ orientation and frequency split give direct insight into the source of quadrature measurement error that corrupts detection of the sensor’s angular rate.Keywords
This publication has 9 references indexed in Scilit:
- Mode Localization Induced by a Nonlinear Control LoopNonlinear Dynamics, 2001
- Mode Localization Induced by a Nonlinear Control Loop2001
- Micromachined inertial sensorsProceedings of the IEEE, 1998
- Modern Inertial Technology1998
- Silicon bulk micromachined vibratory gyroscope for microspacecraft1996
- Silicon Bulk Micromachined Vibratory Gyroscope1996
- An unwindowed multichannel lattice filter with orthogonal channelsIEEE Transactions on Signal Processing, 1995
- Adaptive Identification of a Flexible Structure by a New Multichannel Lattice Filter1992
- Zero Signals in the Sperry Tuning Fork Gyrotron®The Journal of the Acoustical Society of America, 1955