An Internal State Variable Constitutive Model for Deformation of Austenitic Stainless Steels
- 24 August 2012
- journal article
- Published by ASME International in Journal of Engineering Materials and Technology
- Vol. 134 (4) , 041007
Abstract
Austenitic stainless steels—particularly the 304 and 316 families of alloys—exhibit similar trends in the dependence of yield stress on temperature. Analysis of temperature and strain-rate dependent yield stress literature data in alloys with varying nitrogen content and grain size has enabled the definition of two internal state variables characterizing defect populations. The analysis is based on an internal state variable constitutive law termed the mechanical threshold stress model. One of the state variables varies solely with nitrogen content and is characterized with a larger activation volume. The other state variable is characterized by a much smaller activation volume and may represent interaction of dislocations with solute and interstitial atoms. Analysis of the entire stress–strain curve requires addition of a third internal state variable characterizing the evolving stored dislocation density. Predictions of the model are compared to measurements in 304, 304L, 316, and 316L stainless steels deformed over a wide range of temperatures (up to one-half the melting temperature) and strain rates. Model predictions and experimental measurements deviate at temperatures above ∼600 K where dynamic strain aging has been observed. Application of the model is demonstrated in irradiated 316LN where the defect population induced by irradiation damage is analyzed. This defect population has similarities with the stored dislocation density. The proposed model offers a framework for modeling deformation in stable austenitic stainless steels (i.e., those not prone to a martensitic phase transformation).Keywords
This publication has 25 references indexed in Scilit:
- Tensile properties of EC316LN irradiated in SINQ to 20dpaJournal of Nuclear Materials, 2008
- Effect of dynamic strain aging on high temperature properties of austenitic stainless steelMaterials Science and Engineering: A, 2004
- Temperature dependence of strain hardening and plastic instability behaviors in austenitic stainless steelsActa Materialia, 2004
- A unified constitutive model for strain-rate and temperature dependent behavior of molybdenumMechanics of Materials, 2001
- An Experimental and Analytical Study of the Evolution of Crystallographic Texturing in FCC MaterialsTexture, Stress, and Microstructure, 1991
- Low-temperature and high-strain-rate deformation of nickel and nickel-carbon alloys and analysis of the constitutive behavior according to an internal state variable modelActa Metallurgica et Materialia, 1990
- The microstructural origins of yield strength changes in aisi 316 during fission or fusion irradiationJournal of Nuclear Materials, 1981
- Dynamic uniaxial and biaxial stress-strain relationships for austenitic stainless steelsNuclear Engineering and Design, 1980
- Temperature Dependence of the Elastic ConstantsPhysical Review B, 1970
- Plastic deformation of nickel single crystals at low temperaturesPhilosophical Magazine, 1958