The ZVS voltage-mode class-D amplifier, an eGaN® FET-enabled topology for highly resonant wireless energy transfer
Author:
- 1 March 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10482334,p. 1608-1613
Abstract
The popularity of highly resonant, loosely coupled, wireless energy transfer systems operating at 6.78 MHz has increased dramatically over the last few years. In this paper we present the zero voltage switching (ZVS) voltage mode class D amplifier topology and evaluate its performance as a suitable A4WP Class-3 compliant amplifier using eGaN FETs and compare the performance with MOSFETs. Experimental verification has revealed that the ZVS class D amplifier can inherently drive a reflected load impedance range from +20j Ω though -30j Ω and 1.7 Ω through 57 Ω while maintaining A4WP Class-3 compliance, which is a significantly wider range than any other topology explored as of this date. The eGaN FET based amplifier was found to have 30 % lower losses and operate as much as 17°C cooler when delivering 16 W into the load than a MOSFET version.Keywords
This publication has 7 references indexed in Scilit:
- GaN Transistors for Efficient Power Conversion2014
- Design and evaluation of a 10 MHz gallium nitride based 42 V DC-DC converter2014
- Evaluation of gallium nitride transistors in high frequency resonant and soft-switching DC-DC converters2014
- Introduction to the alliance for wireless power loosely-coupled wireless power transfer system specification version 1.02013
- Understanding the effect of PCB layout on circuit performance in a high frequency gallium nitride based point of load converter2013
- A 25.6 W 13.56 MHz wireless power transfer system with a 94% efficiency GaN Class-E power amplifier2012
- Design of high-efficiency RF Class-D power amplifierIEEE Transactions on Power Electronics, 1994