Analysis of a Low-Loss Gear Geometry Using a Thermal Elastohydrodynamic Simulation including Mixed Lubrication
Open Access
- 24 August 2022
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 10 (9) , 200
Abstract
Low-loss gears are an interesting design approach for increasing the efficiency and thermal load limits of gearboxes. The loss-optimized gear geometry concentrates sliding around the pitch point, which results in low load-dependent gear power losses. In this study, a method for modeling transient EHL (elastohydrodynamically lubricated) contacts in gear mesh considering mixed lubrication and thermal effects is introduced and applied to analyze the tribological behavior of a low-loss gear geometry. Special focus is placed on local frictional losses to analyze the role of the thermal effects of the gear mesh. Although a thermal reduction in fluid friction is observed, the overall effect on total frictional losses of the low-loss gear geometry is evaluated to be very small. The edge geometry strongly influences the lubricant film thickness and frictional power losses.Keywords
Funding Information
- German Research Foundation e.V. (DFG) (STA 1198/17-2)
This publication has 31 references indexed in Scilit:
- Behavior of lubricant fluid film in gears under dynamic conditionsTribology International, 2013
- Analysis of Lubricating Performance for Involute Gear Based on Dynamic Loading TheoryJournal of Mechanical Design, 2012
- A thermal finite line contact EHL model of a helical gear pairProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2012
- Thermal elastohydrodynamic simulation of involute spur gears incorporating mixed frictionTribology International, 2012
- Influence factors on gearbox power lossIndustrial Lubrication and Tribology, 2011
- Lubricant thermal conductivity and heat capacity under high pressureProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2000
- Application of Average Flow Model to Lubrication Between Rough Sliding SurfacesJournal of Lubrication Technology, 1979
- An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic LubricationJournal of Lubrication Technology, 1978
- Die Abhängigkeit der Viscosität von der Temperatur bie unterkühlten FlüssigkeitenZeitschrift für anorganische und allgemeine Chemie, 1926
- ANALYSIS OF RECENT MEASUREMENTS OF THE VISCOSITY OF GLASSESJournal of the American Ceramic Society, 1925