Advanced Packed-Bed Ca-Cu Looping Process for the CO2 Capture From Steel Mill Off-Gases
Open Access
- 2 July 2020
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 8
Abstract
A novel configuration of the Ca-Cu looping process based on dynamically operated packed-bed reactors is proposed to convert blast furnace gas (BFG) into H2/N2 and highly concentrated CO2, accompanied by a large amount of high-temperature heat. Preliminary energy and mass balances of the process reveal that around 30% of the BFG can be upgraded via calcium assisted water gas shift (WGS) if only BFG is used as reducing gas in the reduction/calcination stage. A higher amount of H2/N2 can be produced by using other steel mill off gases, such as coke oven gas (COG) or basic oxygen furnace gas (BOFG), or natural gas in the regeneration of the CO2 sorbent. This decarbonized fuel gas could be used for onsite power generation or to obtain sponge iron by a Direct Reduced Iron (DRI) process, increasing the overall capacity of the steel plant. Energy efficiencies higher than 75% have been calculated, reaching maximum values around 88% in case of using natural as fuel gas for the sorbent regeneration stage. Low values for the specific energy consumption of around 1.5 MJLHV/kgCO2 and CO2 capture efficiencies higher than 95% support the further development of the proposed Ca-Cu looping process.Keywords
This publication has 45 references indexed in Scilit:
- Clean Ironmaking and Steelmaking Processes2019
- Complete Ca/Cu cycle for H2 production via CH4 sorption enhanced reforming in a Lab-Scale fixed bed reactorChemical Engineering Journal, 2018
- Optimization of the Iron Ore Direct Reduction Process through Multiscale Process ModelingMaterials, 2018
- Study of a Cu-CuO chemical loop for the calcination of CaCO3 in a fixed bed reactorChemical Engineering Journal, 2017
- CaCO3 calcination by the simultaneous reduction of CuO in a Ca/Cu chemical looping processChemical Engineering Science, 2015
- Thermodynamic analysis of hydrogen production via chemical looping steam methane reforming coupled with in situ CO 2 captureInternational Journal of Greenhouse Gas Control, 2015
- High-temperature pressure swing adsorption cycle design for sorption-enhanced water–gas shiftChemical Engineering Science, 2015
- Post-combustion capture of CO2 at an integrated steel mill – Part I: Technical concept analysisInternational Journal of Greenhouse Gas Control, 2013
- Progress in Chemical-Looping Combustion and Reforming technologiesProgress in Energy and Combustion Science, 2012
- The calcium looping cycle for large-scale CO2 captureProgress in Energy and Combustion Science, 2010