Characterisation of corrosion products formed on PVD in situ mechanically worked Mg–Ti alloys
Authors:
- T. MitchellTMT. Mitchell
- S. DiplasSDS. Diplas
- P. TsakiropoulosP. Tsakiropoulos
- 1 April 2005
- journal article
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 392 (1-2) , 127-141
Abstract
No abstract availableThis publication has 11 references indexed in Scilit:
- Development of physical vapour deposited Mg–Zr alloys Part 3 – Comparison of alloying and corrosion behaviour in Mg–V and Mg–Zr physical vapour deposited alloysMaterials Science and Technology, 1999
- Development of physical vapour deposited Mg–Zr alloys Part 2 – Characterisation of corrosion productsMaterials Science and Technology, 1999
- Calculations of charge transfer in Nb–17Al and V–50Al alloys, using the Auger parameterIntermetallics, 1999
- Development of Mg–V alloys by physical vapour deposition Part 2 – Characterisation of corrosion products formed in 3 vvt-%NaCIMaterials Science and Technology, 1998
- Development of Mg–V alloys by physical vapour deposition Part 1 – Bulk and surface characterisationMaterials Science and Technology, 1998
- Corrosion behaviour of some vapour deposited magnesium alloysMaterials Science and Technology, 1996
- Charge transfer across the As/Si(100)-2×1 interfacePhysical Review B, 1992
- The structure and morphology of the corrosion products formed on the surfaces of a rapidly solidified Mg3.5Al alloyMaterials Science and Engineering: A, 1991
- Initial and final state effects in the ESCA spectra of cadmium and silver oxidesThe Journal of Chemical Physics, 1977
- Chemical shifts of Auger lines, and the Auger parameterFaraday Discussions of the Chemical Society, 1975