Microstructure and Mechanical Properties of Low-Cost SiC-Reinforced Aluminum and Al4Cu Matrix Composites Produced by Sintering in Vacuum
Open Access
Abstract
Composite materials based on Al and Al4Cu with the addition of SiC particles (2.5; 5; 7.5; 10 wt.%) were produced in low-cost conventional powder metallurgy processes involving mixing, compacting with a pressure of 300 MPa, and sintering at 600 °C in a vacuum atmosphere. An attempt was made to create a relationship between the vacuum sintering and the microstructure and mechanical properties of Al/SiC composites. The strength of the matrix-reinforcing interface depends on the chemical composition of the components; therefore, the influence of 4 wt.% copper in the aluminum matrix was investigated. Comprehensive microstructural and mechanical properties (including Brinell hardness, compressive and flexural strength measurements) of the produced composites were measured. The addition of 2.5 wt.% SiC to the Al4Cu matrix improved the mechanical properties of the composites compared to the matrix. In the composite with the addition of 2.5 wt.% of SiC, while the addition of the reinforcement did not affect the hardness and compressive strength and caused a rapid decrease in the flexural strength compared to the aluminum matrix, the addition of Cu to the matrix of this composite improved hardness (from 25 to 49 HB), compressive strength (from 423 to 618 MPa), and flexural strength (from 52 to 355 MPa).Keywords
This publication has 23 references indexed in Scilit:
- B4C-Al Composites Fabricated by the Powder Metallurgy ProcessApplied Sciences, 2017
- Fabrication characteristics and tribological behavior of Al/SiC/Gr hybrid aluminum matrix composites: A reviewFriction, 2016
- Effect of matrix/reinforcement particle size ratio (PSR) on the mechanical properties of extruded Al–SiC compositesThe International Journal of Advanced Manufacturing Technology, 2014
- Mechanical properties and interfacial analysis of aluminum matrix composites reinforced by carbon nanotubes with diverse structuresMaterials Science and Engineering: A, 2013
- Fabrication of SiC nanoparticulates reinforced Al matrix composites by combining pressureless infiltration with ball-milling and cold-pressing technologyJournal of Alloys and Compounds, 2010
- The effect of mechanical alloying on SiC distribution and the properties of 6061 aluminum compositeJournal of Materials Processing Technology, 2005
- Effects of copper addition on the sintering behavior and mechanical properties of powder processed Al/SiCp compositesJournal of Materials Science, 2005
- Heat treatment and wear characteristics of Al/SiCp composites fabricated by duplex processComposites Part B: Engineering, 2003
- Effect of limited matrix–reinforcement interfacial reaction on enhancing the mechanical properties of aluminium–silicon carbide compositesActa Materialia, 2001
- Liquid phase sintering of aluminium alloysMaterials Chemistry and Physics, 2001