Bioinspired engineering polymers by voxel-based 3D-printing
Authors:
- Theresa SwetlyTSTheresa Swetly
- Jürgen StampflJürgen Stampfl
- Gero KempfGKGero Kempf
- Rainer-Michael HuckeRHRainer-Michael Hucke
- Marcus WillingMWMarcus Willing
- Marina WarkentinMWMarina Warkentin
- 1 January 2016
- journal article
- Published by Walter de Gruyter GmbH in BioNanoMaterials
- Vol. 17 (3-4)
Abstract
Additive manufacturing (AM) has become an important tool in the product development process as it offers the possibility to produce parts of good geometrical quality within a short period of time, allowing geometrical validations and the visualisation of ideas. Yet the application of AM is often limited due to the poor mechanical properties of AM parts. In the automotive sector for example, there is a high demand for tough AM parts which have an impact strength comparable to industrially moulded thermoplasts. This paper explores the possibility to increase the impact strength of AM parts by combining a stiff, hard and brittle component (VeroWhite Plus in this instance) with a soft, elastomer-like component (TangoBlack Plus) and arranging these on a micro-scale level in form of alternating, chess-pattern voxels. While one material was responsible for maintaining a sufficient stiffness and strength of the resulting composite structure, the other material acted as an obstacle for crack propagation. Varying the edge length of the voxels, it was possible to investigate the influence of the microscopic voxel geometry on the part’s macroscopic impact strength. It was shown that the Charpy impact strength could be raised by a factor of eight (from 10.9 kJ/mKeywords
This publication has 24 references indexed in Scilit:
- Laser sintering of polyamides and other polymersProgress in Materials Science, 2012
- Deformation and Fracture Mechanisms of Bone and NacreAnnual Review of Materials Research, 2011
- Structural hierarchies define toughness and defect-tolerance despite simple and mechanically inferior brittle building blocksScientific Reports, 2011
- Crack arrest within teeth at the dentinoenamel junction caused by elastic modulus mismatchBiomaterials, 2010
- Flexural strength and Weibull analysis of a microhybrid and a nanofill composite evaluated by 3- and 4-point bending testsDental Materials, 2008
- Hindered Crack Propagation in Materials with Periodically Varying Young's Modulus—Lessons from Biological MaterialsAdvanced Materials, 2007
- Binding mechanisms in selective laser sintering and selective laser meltingRapid Prototyping Journal, 2005
- Short fiber reinforced composites for fused deposition modelingMaterials Science and Engineering: A, 2001
- A review of process planning techniques in layered manufacturingRapid Prototyping Journal, 2000
- A comparison of rapid prototyping technologiesInternational Journal of Machine Tools and Manufacture, 1998