Twin Roll Caster for Clad Strip
Author:
Open Access
Abstract
Production of aluminum alloy clad strips requires many processes, and a reduction in the number of processes has long been demanded. A method to cast clad strips directly from molten metal using a twin roll caster with copper rolls is proposed in this work. Two types of twin roll casters were designed and tested. One was a vertical-type tandem twin roll caster and the other was a twin roll caster equipped with a scraper. The casting of the clad strips was conducted in an oxidizing atmosphere. The clad strips were cast at speeds higher than 15 m/min. This casting speed is much higher than that of conventional twin roll casters for aluminum alloys. The roll load was smaller than 0.2 kN/mm. This small roll load means that strips were not bonded by hot rolling. The clad strips had a clear interface between strips, and elements in each strip did not diffuse into other strips. The clad strips did not fracture at the interface in a tension shear test. This means that the clad strips were strongly bonded.Keywords
This publication has 26 references indexed in Scilit:
- Roll Casting of Clad StripMaterials Science Forum, 2012
- Clad Strip Casting by a Roll CasterApplied Mechanics and Materials, 2011
- Clad Strip Casting Using a Twin Roll CastersAdvanced Materials Research, 2011
- Roll Casting of Three Layers Clad StripKey Engineering Materials, 2010
- Casting of Aluminum Alloy Clad Strip Using a Vertical Type Tandem Twin Roll CasterAdvanced Materials Research, 2010
- Downstream Considerations of Fusion Clad CastingMaterials Science Forum, 2009
- Direct Chill Casting of CLAD IngotMaterials Science Forum, 2006
- Microdefects formation during the twin-roll casting of Al–Mg–Mn aluminium alloysJournal of Materials Processing Technology, 2005
- A twin-roll caster to cast clad stripJournal of Materials Processing Technology, 2003
- Development of the twin-roll casting processJournal of Materials Processing Technology, 1995