Bone Density Assessment Through Sodium Poly-Tungstate Gradient Centrifugation: A Preliminary Study on Decades-Old Human Samples
Authors:
- Barbara Di StefanoBSBarbara Di Stefano
- Chiaramaria StaniCSChiaramaria Stani
- Giorgio MarrubiniGiorgio Marrubini
- Barbara BertoglioBBBarbara Bertoglio
- Solange Sorçaburu CiglieriSCSolange Sorçaburu Ciglieri
- Serena BoninSerena Bonin
- Carlo PreviderèCPCarlo Previderè
- Giovanni BirardaGBGiovanni Birarda
- Paolo FattoriniPFPaolo Fattorini
Open Access
- 27 September 2025
- journal article
- research article
- Published by MDPI AG in Separations
- Vol. 12 (10) , 263
Abstract
Bone density is considered one of the many factors influencing bone structure and DNA preservation. For this reason, it is of interest in fields such as anthropology, palaeontology, and genetics. This study describes a method for bone density assessment by gradient centrifugation in Sodium Poly-Tungstate (SPT) solutions (from 2.1 to 2.6 g/cm3). Fifty milligrams of bone powder (size range of 20–50 µm) were used, with an average recovery of 89.9 (IC = 3.3% at 95% of probability). In the first phase of the experiment, the protocol was applied to ten femurs: three exhumed from the WWII mass grave of Ossero, three aged (43–50 years old) femurs from a museum collection and four fresh controls. In the subsequent phase, the analysis was extended to three petrous bones, three metacarpals, and three metatarsals exhumed from the WWII mass grave. The SPT density gradient profiles revealed marked differences among the three femur sample sets: more than 80% of the powder from control femurs was recovered in fractions with a density ≤ 2.2 g/cm3, whereas approximately 45% of the femurs from the mass grave showed a density > 2.6 g/cm3. The remaining three aged femurs displayed peculiar density patterns. Among the other bone types, metatarsals showed the lowest density values, followed by petrous bones and metacarpals. To detect degradation signatures, all nineteen bone powders were also analysed by ATR-FTIR. The femurs from the mass grave exhibited spectral features consistent with mineral recrystallisation and degradation of the organic phase, whereas the other three aged femurs showed peculiar spectral profiles; metacarpals, petrous bones and metatarsals showed intermediate spectra. PCA was applied to SPT and ATR-FTIR data, revealing correlations that support the SPT method as a novel tool for bone quality assessment. Although based on a limited sample size, this preliminary work demonstrates that SPT gradient analysis is an effective, low-cost, rapid and reliable method for assessing bone density, with potential applications in different disciplines studying aged bone samples. Lastly, principal component analysis (PCA) revealed a correlation between bone density and the yield of DNA recovered from the ten femoral specimens.Keywords
This publication has 42 references indexed in Scilit:
- Beyond metrics and morphology: the potential of FTIR-ATR and chemometrics to estimate age-at-death in human boneInternational journal of legal medicine, 2020
- Pick the Right Pocket. Sub‐sampling of Bone Sections to Investigate Diagenesis and DNA PreservationInternational Journal of Osteoarchaeology, 2016
- Extraction of DNA from Human Skeletal Material2016
- The Chemical and Microbial Degradation of Bones and Teeth2007
- Determining isotopic life history trajectories using bone density fractionation and stable isotope measurements: A new approachAmerican Journal of Physical Anthropology, 2001
- Infrared and Isotopic Evidence for Diagenesis of Bone Apatite at Dos Pilas, Guatemala: Palaeodietary ImplicationsJournal of Archaeological Science, 1996
- Bones and Groundwater: Towards the Modelling of Diagenetic ProcessesJournal of Archaeological Science, 1995
- Age‐related changes in the human femoral cortexJournal of Orthopaedic Research, 1991
- Sex differences in peak adult bone mineral densityJournal of Bone and Mineral Research, 1990
- Density gradient fractionation of dentine and bone powderCalcified Tissue International, 1974