Load-bearing capacity testing of dowel pin anchorage in granite cladding
- 1 July 2020
- journal article
- research article
- Published by Emerald Publishing in Proceedings of the Institution of Civil Engineers - Structures and Buildings
- Vol. 173 (7) , 501-511
Abstract
To investigate the load-bearing capacity of a dowel pin anchorage, monotonic tests were performed. Results show that the ideal failure mode of the dowel pin cladding system is plastic shear or shear and bending deformation of the steel pin prior to rupture of the dowel. It was also found that the maximum load-bearing capacity of a 5 mm pin with sleeve is 30% higher than that without a sleeve, while that of the 8 mm pin system with sleeve is only 6% higher than that without sleeve, which means that the existence of the sleeve contributes to the load-bearing capacity to some extent. Cladding with 5 mm steel pins has two failure stages, namely, pin yielding and panel rupture, which allow the steel pins to deform plastically and dissipate energy before total failure of the anchorage. Cladding with 8 mm pins has only one failure stage, namely, sudden rupture of the panel without any prior warning signs. The rupture surface of the panel has an angle of 24° to 29° on the side surface, and 27° to 33° on the top surface. More comprehensive experimental and analytical studies are needed to develop a reliable calculation method of the failure load.Keywords
This publication has 14 references indexed in Scilit:
- Behavior of adhesive bonded anchors under tension and shear loadsJournal of Constructional Steel Research, 2015
- Seismic Performance of Precast Industrial Facilities Following Major Earthquakes in the Italian TerritoryJournal of Performance of Constructed Facilities, 2015
- Modeling and analysis of the shear capacity of adhesive anchors post-installed into uncracked concreteComposites Part B: Engineering, 2014
- Stone Cladding Engineering2014
- Failure of industrial structures induced by the Emilia (Italy) 2012 earthquakesEngineering Failure Analysis, 2013
- Tensile behavior of post-installed chemical anchors embedded to low strength concreteConstruction and Building Materials, 2013
- Performance of industrial buildings during the Emilia earthquakes in Northern Italy and recommendations for their strengtheningBulletin of Earthquake Engineering, 2013
- Shear strength of epoxy anchors embedded into low strength concreteConstruction and Building Materials, 2013
- Dimension-stone cladding design with dowel anchorageProceedings of the Institution of Civil Engineers - Construction Materials, 2009
- 3. The Whittier Narrows, California Earthquake of October 1, 1987—Performance of Buildings at California State University, Los AngelesEarthquake Spectra, 1988