ATPG for heat dissipation minimization during test application
Authors:
- 17 December 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 47 (10893539) , 250-258
Abstract
A new ATPG algorithm has been proposed that reduces average heat dissipation (between successive test vectors) during test application. The objective is to permit safe and inexpensive testing of low power circuits and bare dies that would otherwise require expensive heat removal equipment for testing at high speeds. Three new functions, namely transition controllability, observability and test generation costs, have been defined. It has been shown that the transition test generation cost is the minimum number of transitions required to test the corresponding stuck-at fault in fanout free circuits. This cost function is used for target fault selection while the other two functions are used to guide the backtrace and objective selection procedures of PODEM. The tests generated by the proposed ATPG decrease heat dissipation during test application by a factor of 2-23 for benchmark circuits.Keywords
This publication has 15 references indexed in Scilit:
- Bare die testing and MCM probing techniques2003
- Bare die test2003
- Two techniques for minimizing power dissipation in scan circuits during test application2002
- An optimization based approach to the partial scan design problem2002
- Partial scan by use of empirical testability2002
- Overall consideration of scan design and test generation1992
- An algorithm to reduce test application time in full scan designs1992
- A partial scan method for sequential circuits with feedbackIEEE Transactions on Computers, 1990
- The Ballast methodology for structured partial scan designIEEE Transactions on Computers, 1990
- An Implicit Enumeration Algorithm to Generate Tests for Combinational Logic CircuitsIEEE Transactions on Computers, 1981