Comparison between Ramp Pulse Modulation (RPM) and constant frequency modulation for the beat frequency oscillation in voltage regulators
Authors:
- 1 September 2010
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 3101-3106
Abstract
In the voltage regulator (VR) applications, the load frequency varies in a very wide range from several kHz to several MHz. When the load transient frequency approaches to the switching frequency of VR, there is a low frequency oscillation in the system, which is the beat frequency oscillation between the load transient frequency and the switching frequency of VR. When this low frequency oscillation becomes significant, the system may be hurt. The root cause of this beat frequency oscillation is constant frequency operation of the VR. In order to resolve this problem, Ramp Pulse Modulation (RPM) method is proposed. A Ramp Pulse Modulation control is one of the ripple based control methods, which is generally used in the single phase voltage regulators. In this paper, RPM method is reviewed and it is compared to the constant frequency control method with experiments.Keywords
This publication has 5 references indexed in Scilit:
- Ripple-Based Control of Switching Regulators—An OverviewIEEE Transactions on Power Electronics, 2009
- A Hysteretic Control Method for Multiphase Voltage RegulatorIEEE Transactions on Power Electronics, 2009
- Analysis and Design of the Dual Edge Controller for the Fast Transient Voltage Regulator2009
- Analysis and Modeling of Voltage Mode Controlled Phase Current Balancing Technique for Multiphase Voltage Regulator to Power High Frequency Dynamic Load2009
- Optimal design of the active droop control method for the transient response2004