Development of an inspection robot for small diameter gas distribution mains
- 1 May 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10504729,p. 5044-5049
Abstract
This paper discusses the design of a mechanical structure of a miniature pipe inspection robot capable of moving through very small pipes (down to 41 mm inner diameter). The requirement to negotiate bends, T-joints and steep inclinations pose another set of strict design constraints. The proposed robot consists of a modular design (7 modules) with a relatively low number of active degrees of freedom. The system is using a novel clamping mechanism with a series-elastic drive. The design of this mechanism has resulted in a high spreading factor allowing the system to operate in a wide diameter range (63 mm to 125 mm outer diameter). In this paper the mechanical design requirements and control system will be discussed. Preliminary test results will be given.Keywords
This publication has 5 references indexed in Scilit:
- Visual and nondestructive evaluation inspection of live gas mains using the Explorer™ family of pipe robotsJournal of Field Robotics, 2010
- Differential-drive in-pipe robot for moving inside urban gas pipelinesIEEE Transactions on Robotics, 2005
- A miniature inspection robot negotiating pipes of widely varying diameter2004
- Software approach for the autonomous inspection robot MAKRO2004
- Series elastic actuators2002