Analysis of Parallel-Connected Asymmetrical Soft-Switching Converter
Authors:
- 30 April 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Industrial Electronics Magazine
- Vol. 54 (3) , 1642-1653
Abstract
A new half-bridge converter with two current-doubler rectifiers is proposed. Two transformers are used in the proposed converter. The primary windings of two transformers are connected in series to reduce the voltage stress across the magnetizing inductor, since each magnetizing inductor voltage is equal to one half of the input voltage. Two current-doubler rectifiers at the secondary sides are connected in parallel to reduce the current stress of secondary winding since the secondary winding current is less than one half of the load current. The asymmetrical pulsewidth-modulation technique is used in the proposed converter to regulate the direct current output voltage. The transformer leakage inductance and the output capacitance of switching switches are resonant during the transition interval between two switches in order to achieve zero voltage switching. The operation principle and design considerations of the proposed converter are provided. Experimental results for a 100-W (5 V/20 A) prototype are presented to verify the theoretical analysis and circuit performanceKeywords
This publication has 13 references indexed in Scilit:
- A Comprehensive Analysis of Hybrid Phase-Modulated Converter With Current-Doubler Rectifier and Comparison With Its Center-Tapped CounterpartIEEE Transactions on Industrial Electronics, 2006
- Active Voltage Clamp in Flyback Converters Operating in CCM Mode Under Wide Load VariationIEEE Transactions on Industrial Electronics, 2004
- Calculation of the Resonant Capacitor of the Improved Current-Doubler-Rectifier ZVS PWM Full-Bridge ConverterIEEE Transactions on Industrial Electronics, 2004
- Current Distribution Control Design for Paralleled DC/DC Converters Using Sliding-Mode ControlIEEE Transactions on Industrial Electronics, 2004
- The ZVS-PWM Active-Clamping CUK ConverterIEEE Transactions on Industrial Electronics, 2004
- A new ZVS-PWM full-bridge converterIEEE Transactions on Power Electronics, 2003
- Robust average current-mode control of multimodule parallel DC-DC PWM converter systems with improved dynamic responseIEEE Transactions on Industrial Electronics, 2001
- Design and performance evaluation of low-voltage/high-current DC/DC on-board modulesIEEE Transactions on Power Electronics, 2001
- Asymmetrical pulse-width-modulated resonant DC/DC converter topologiesIEEE Transactions on Power Electronics, 1996
- Evaluation of synchronous-rectification efficiency improvement limits in forward convertersIEEE Transactions on Industrial Electronics, 1995