Measurements and analysis of adhesive forces for micron particles on common indoor surfaces
Authors:
- 15 July 2019
- journal article
- research article
- Published by SAGE Publications in Indoor and Built Environment
- Vol. 29 (7) , 931-941
Abstract
Dust particle resuspension from indoor surfaces is an important source of particulate matter in indoor environments. The adhesive force represents the resistance of the particle to resuspension in an air stream and is a key factor in the resuspension process. The present study used an atomic force microscope (AFM) to measure the adhesive forces between three particle samples and four common indoor surfaces including acrylic, marble, epoxy flooring and wood flooring. The effects of different indoor surfaces were investigated using 12 particle–surface combinations. The results show that the average adhesive forces range from 8.2 nN to 448.1 nN for different combinations with the surface roughness being the main factor. The average adhesive force increases with the contact radius and is larger on the wood flooring surface than on the other three surfaces. Then, the resuspension process was simulated using the moment balance method with the measured adhesive forces as the model inputs. The model predictions show that the wood flooring surface has the largest resistance to the air flow entrainment, followed by the epoxy flooring surface, then the marble surface and the least is the acrylic surface.Keywords
Funding Information
- National Key R&D Program of China (2016YFC0202700)
- National Natural Science Foundation of China (51676112)
- State Environmental Protection Key Laboratory of Sources and Control of Air Pollution Complex
This publication has 35 references indexed in Scilit:
- Wind tunnel study and numerical simulation of dust particle resuspension from indoor surfaces in turbulent flowsJournal of Adhesion Science and Technology, 2013
- Source apportionment of indoor residential fine particulate matter using land use regression and constrained factor analysisIndoor Air, 2010
- Impact of Airflow Characteristics on Particle Resuspension from Indoor SurfacesAerosol Science and Technology, 2009
- Composition of Household Dust in Semi-urban Areas in MalaysiaIndoor and Built Environment, 2009
- Measurements and Factorial Analysis of Micron-Sized Particle Adhesion Force to Indoor Flooring Materials by Electrostatic Detachment MethodAerosol Science and Technology, 2008
- Current State of the Science: Health Effects and Indoor Environmental QualityEnvironmental Health Perspectives, 2007
- Force measurements with the atomic force microscope: Technique, interpretation and applicationsSurface Science Reports, 2005
- Individual particle analysis of indoor, outdoor, and community samples from the 1998 Baltimore particulate matter studyAtmospheric Environment, 2001
- Adhesion moment model for estimating particle detachment from a surfaceJournal of Aerosol Science, 1997
- On the resuspension of small particles by a turbulent flowJournal of Physics D: Applied Physics, 1988