Durability, Capillary Rise and Water Absorption Properties of a Fiber-Reinforced Cement-Stabilized Fly Ash–Stone Dust Mixture
Authors:
- Sanjeeb Kumar MohantySMSanjeeb Kumar Mohanty
- Nirmal Kumar PanditNPNirmal Kumar Pandit
- Pawan Kumar SahPSPawan Kumar Sah
- Niraj MahasethNMNiraj Mahaseth
- Rajesh YadavRYRajesh Yadav
- Dipti Ranjan BiswalDBDipti Ranjan Biswal
- Benu Gopal MohapatraBMBenu Gopal Mohapatra
- Brundaban BerihaBBBrundaban Beriha
- Ramachandra PradhanRPRamachandra Pradhan
- Sujit Kumar PradhanSPSujit Kumar Pradhan
Open Access
- 25 January 2024
- journal article
- research article
- Published by MDPI AG in Infrastructures
- Vol. 9 (2) , 17
Abstract
The management of unutilized fly ash poses challenges due to concerns about storage and its potential groundwater contamination. Within the road industry, where the bulk utilization of fly ash is feasible, its unsuitability for use in the base and sub-base layers of pavements due to its low strength and a high proportion of fine particles has been a limitation. The incorporation of stone dust alongside fly ash, treated with lime or cement, yields superior strength and stiffness. Apart from strength, the stabilized mix’s durability, capillary rise, and water absorption properties are crucial for determining its suitability for pavement applications. Observations from this study reveal that fiber-reinforced cement-stabilized fly ash–stone aggregate specimens treated with 4% and 6% cement, with and without fibers, met the limiting mass loss of 20%, as specified in IRC SP: 89. The mass loss decreases with an increase in cement and fiber content. However, the capillary rise in the mixes increases with a higher percentage of fly ash and fiber content but decreases with increased cement content. Cement addition results in a reduction in water absorption; however, the addition of fibers results in an increase in water absorption. A linear correlation has been established between mass loss and UCS and IDT, which can be used to evaluate the suitability of materials for the structural layer without conducting a wet–dry durability test, which typically takes one month. This study proposes that cement-stabilized fly ash and stone aggregate mixtures with 4% and 6% cement can be used as the subbase and base of pavement based on wet–dry mass loss criteria and water absorption criteria. Observations from this study reveal that fiber-reinforced cement-stabilized fly ash–stone aggregate specimens treated with 4% and 6% cement, with and without fibers, met the limiting mass loss of 20%, as specified in IRC SP: 89. The mass loss decreases with an increase in cement and fiber content. However, the capillary rise in the mixes increases with a higher percentage of fly ash and fiber content but decreases with increased cement content. Cement addition results in reduction in water absorption. However, the addition of fibers results in increase in water absorption. A linear correlation is established between mass loss and UCS and IDT, which can be used to evaluate the suitability of materials for the structural layer without conducting wet–dry durability tests, which take one month. This study proposes that cement-stabilized fly ash and stone aggregate mixtures with 4% and 6% cement can be used as the subbase and base of pavement based on wet–dry mass loss criteria and water absorption criteria.Keywords
This publication has 21 references indexed in Scilit:
- Comparison of Industrial Waste Mixtures for Use in Subbase Course of Flexible PavementsJournal of Materials in Civil Engineering, 2018
- Durability and shrinkage studies of cement stabilsed granular lateritic soilsInternational Journal of Pavement Engineering, 2018
- Effect of the superplasticizer type on the properties of the fly ash blended cementConstruction and Building Materials, 2014
- Sustainable Reuse of Limestone Quarry Fines and RAP in Pavement Base/Subbase LayersJournal of Materials in Civil Engineering, 2012
- The Influence of Lime Water as Mixing Water on the Compressive Strength Development of High Volume Ultra Fine Fly Ash Mortar2011
- Construction of an Embankment with a Fly and Bottom Ash Mixture: Field Performance StudyJournal of Materials in Civil Engineering, 2009
- Strength Characteristics of Class F Fly Ash Modified with Lime and GypsumJournal of Geotechnical and Geoenvironmental Engineering, 2007
- Factors Influencing the Strength of Cement Fly Ash Base CoursesJournal of Transportation Engineering, 2003
- Basaltic Crushed Rock Stabilized with Cementitious Additives: Compressive Strength and Stiffness, Drying Shrinkage, and Capillary Flow CharacteristicsTransportation Research Record: Journal of the Transportation Research Board, 2003
- Long-Term Strength and Durability of Soil CementJournal of Materials in Civil Engineering, 2001