Kinetics and reaction mechanism of catalytic oxidation of low concentrations of hydrogen sulfide in natural gas over activated carbon
Authors:
- 1 October 1998
- journal article
- research article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 76 (5) , 902-914
Abstract
The kinetics of the hydrogen sulfide oxidation process, producing mostly sulfur and water, was studied using 0.25 to 1.0 g Hydrodarco activated carbon catalyst and varying the O2/H2S ratio (molar basis) in the feed gas between 0.5 to 0.6 in the temperature, and pressure ranges from 125 to 200°C and 225 to 780 kPa. SO2 was obtained as an undesirable by‐product during H2S oxidation reaction or as a product during regeneration of the catalyst. The feed gas contained 0.9 — 1.3 mol% H2S with approximately 80 mol% CH4. In this paper, the factors affecting the H2S conversion and SO2 formation are presented. The rate expressions for (a) H2S conversion and (b) SO2 formation were developed from the Langmuir‐Hinshelwood surface control reaction model. The experimental data were well correlated by the rate equations. Also, the rate parameters were evaluated and correlated with temperature. The activation energies for H2S oxidation and SO2 production reactions were calculated to be 34.2 and 62.5 kJ/mol, respectively. Partial pressures of oxygen and H2S were found to influence H2S conversion whereas, the presence of water in the feed gas up to 10.5 mol% did not affect H2S conversion significantly. Heats of adsorption for various species on the active sites were calculated. SO2 production was, as expected, enhanced at higher temperature, and its rate was much smaller than the oxidation rate of H2S under the reaction conditions used.Keywords
This publication has 12 references indexed in Scilit:
- The effects of pressure and temperature on the catalytic oxidation of hydrogen sulfide in natural gas and regeneration of the catalyst to recover the sulfur producedThe Canadian Journal of Chemical Engineering, 1993
- Kinetics of Hydrogen Sulfide Oxidation Over an Activated Carbon Catalyst in the Pressure Range of 712-3463 kPa and Temperature Range of 110-240 °C.1992
- Catalyst modification and process design considerations for the oxidation of low concentrations of hydrogen sulfide in natural gasThe Canadian Journal of Chemical Engineering, 1990
- Kinetics and reaction mechanism of hydrogen sulfide oxidation over activated carbon in the temperature range of 125–200°cThe Canadian Journal of Chemical Engineering, 1986
- A continuous process for recovery of sulfur from natural gas containing low concentrations of hydrogen sulfideThe Canadian Journal of Chemical Engineering, 1986
- Oxidation of low concentrations of hydrogen sulfide by air on a fixed activated carbon bedThe Canadian Journal of Chemical Engineering, 1983
- Oxidation of low concentrations of hydrogen sulfide over activated carbonThe Canadian Journal of Chemical Engineering, 1980
- The mechanism of the catalytic oxidation of hydrogen sulfide *1II. Kinetics and mechanism of hydrogen sulfide oxidation catalyzed by sulfurJournal of Catalysis, 1976
- Oxidation of hydrogen sulfide over microporous carbonsCarbon, 1975
- Oxidation of H2S on active carbon catalyst*1Journal of Catalysis, 1975