Laboratory-Scale Simulation of Runoff Response from Pervious-Impervious Systems
Authors:
- 1 September 2008
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydrologic Engineering
- Vol. 13 (9) , 886-893
Abstract
We posit that a more complete understanding of runoff response from urban catchments requires an assessment of the hydrologic behavior of composite impervious-pervious patches. We therefore examined how the factors of impervious extent, connectivity, and antecedent moisture content of pervious areas might affect mechanisms of runoff production at small spatial scales in a laboratory setting. We used rainfall simulation (with a storm comprised of rainfall rates for 48, 24, and , respectively) to observe surface runoff from boxes (impervious or pervious-soil) deep that were connected together in series to produce different arrangements of impervious and pervious surfaces (0, 25, 50% impervious) with different connectivity to the outlet (disconnected, connected), and under two different antecedent moisture conditions for pervious areas (drier, wetter). In general, an increase in percent impervious area led to fewer opportunities for infiltration, and a quicker onset of runoff, which was intensified by wetter antecedent moisture conditions and connectivity to the outlet. Runoff rate ratios were strongly affected by antecedent moisture condition and somewhat less significantly by an interaction between impervious area extent and its connectivity status. In each impervious treatment, we observed a decreased time to runoff initiation and higher final runoff rate ratio for wetter than drier treatments. Interestingly, we found that the connectivity of 25% impervious area accounted for differences in runoff rate ratio only early in the simulation. The patterns in runoff from connected and disconnected 25% treatments eventually converged, leaving antecedent moisture conditions the only relevant factor. As impervious area was increased to 50%, we noted a precipitous decline in infiltration rates due to a reduction in infiltration opportunities and infiltration behavior of the pervious surfaces in these treatments. Evidence of return flow in the 50% disconnected treatment is presented and discussed in the context of saturation-excess runoff mechanisms. These experimental results are then discussed in terms of their potential extension and application to better understand aspects of urban hydrology and models thereof.
Keywords
This publication has 10 references indexed in Scilit:
- Impervious surface impacts to runoff and sediment discharge under laboratory rainfall simulationCATENA, 2008
- Upscaling of saturated conductivity for Hortonian runoff modellingAdvances in Water Resources, 2006
- Role of run-on for describing field-scale infiltration and overland flow over spatially variable soilsJournal of Hydrology, 2004
- Estimation of Urban Imperviousness and its Impacts on Storm Water SystemsJournal of Water Resources Planning and Management, 2003
- Study of pollutant washoff from small impervious experimental plotsWater Resources Research, 2003
- Partitioning total erosion on unpaved roads into splash and hydraulic components: The roles of interstorm surface preparation and dynamic erodibilityWater Resources Research, 2000
- URBANIZATION OF AQUATIC SYSTEMS: DEGRADATION THRESHOLDS, STORMWATER DETECTION, AND THE LIMITS OF MITIGATION1Jawra Journal of the American Water Resources Association, 1997
- Methodology for Determining Hydraulic Conductivity with Tension InfiltrometersSoil Science Society of America Journal, 1993
- Analytical Solutions of a Simplified Flow EquationTransactions of the ASAE, 1976
- Runoff From Impervious SurfacesJournal of Hydraulic Research, 1964