Synchronous Double-Pumping Technique for Integrated Current-Mode PWM DC–DC Converters Demand on Fast-Transient Response
Authors:
- 2 March 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 32 (1) , 849-865
Abstract
While the fast transient techniques have been extensively investigated, the research aiming at current-mode pulse width modulation (PWM) converters is relatively unexplored. This paper presents a synchronous double-pumping (SDP) technique for current-mode PWM dc-dc converters to achieve fast-transient response between different load conditions. The advantages and limitations of the existing conventional techniques are discussed and analyzed. With the proposed SDP technique, a nearly optimized recovery time speedup and voltage drop minimization for every different conventional current-mode converters can be obtained. The prototype chip was fabricated using a TSMC 0.35-μm CMOS process occupies the area of 2.242 mm 2 including all bonding pads and ESD protection circuits. The output voltage ripple is measured about 15 mV in peak-to-peak value. The recovery time is 2.4 and 2.6 μs, respectively, in response to the 400-mA step-up and step-down load changes. Those are improved by a factor of 8.33 and 8.23, respectively.Keywords
Funding Information
- Ministry of Science and Technology, Taiwan (MOST104-2220-E-002-014)
This publication has 31 references indexed in Scilit:
- Pulsewidth Modulated Dc‐to‐Dc Power Conversion2013
- Green Computing with Emerging Memory2013
- Fast Transient (FT) Technique With Adaptive Phase Margin (APM) for Current Mode DC-DC Buck ConvertersIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 2011
- Area- and Power-Efficient Monolithic Buck Converters With Pseudo-Type III CompensationIEEE Journal of Solid-State Circuits, 2010
- Quadratic Differential and Integration Technique in $V^{2}$ Control Buck Converter With Small ESR CapacitorIEEE Transactions on Power Electronics, 2009
- Roadmap for 22nm and beyond (Invited Paper)Microelectronic Engineering, 2009
- Adaptive Pole-Zero Position (APZP) Technique of Regulated Power Supply for Improving SNRIEEE Transactions on Power Electronics, 2008
- Fast-Transient DC–DC Converter With On-Chip Compensated Error AmplifierIEEE Transactions on Circuits and Systems II: Express Briefs, 2007
- Analog Circuit Design Techniques at 0.5 V2007
- Supply and threshold voltage scaling for low power CMOSIEEE Journal of Solid-State Circuits, 1997