Modal decomposition method for acoustic impedance testing in square ducts
Authors:
- 1 December 2006
- journal article
- conference paper
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 120 (6) , 3750-3758
Abstract
Accurate duct acoustic propagation models are required to predict and reduce aircraft engine noise. These models ultimately rely on measurements of the acoustic impedance to characterize candidate engine nacelle liners. This research effort increases the frequency range of normal-incidence acoustic impedance testing in square ducts by extending the standard two-microphone method (TMM), which is limited to plane wave propagation, to include higher-order modes. The modal decomposition method (MDM) presented includes four normal modes in the model of the sound field, thus increasing the bandwidth from for a square waveguide. The MDM characterizes the test specimen for normal- and oblique-incident acoustic impedance and mode scattering coefficients. The MDM is first formulated and then applied to the measurement of the reflection coefficient matrix for a ceramic tubular specimen. The experimental results are consistent with results from the TMM for the same specimen to within the 95% confidence intervals for the TMM. The MDM results show a series of resonances for the ceramic tubular material exhibiting a monotonic decrease in the resonant peaks of the acoustic resistance with increasing frequency, resembling a rigidly-terminated viscous tube, and also evidence of mode scattering is visible at the higher frequencies.
Keywords
This publication has 15 references indexed in Scilit:
- Comparison of methods for determining specific acoustic impedanceThe Journal of the Acoustical Society of America, 1997
- Modal decomposition in ducts based on transfer function measurements between microphone pairsJournal of Sound and Vibration, 1989
- Evaluation of a multi-point method for determining acoustic impedanceMechanical Systems and Signal Processing, 1989
- Development of a method of determining the transverse wave structure in a rigid wall axisymmetric ductThe Journal of the Acoustical Society of America, 1985
- A modal separation measurement technique for broadband noise propagating inside circular ductsJournal of Sound and Vibration, 1981
- Transfer function method of measuring in-duct acoustic properties. I. TheoryThe Journal of the Acoustical Society of America, 1980
- Measurement of radial and circumferential modes in annular and circular fan ductsJournal of Sound and Vibration, 1979
- Experimental determination of three-dimensional liquid rocket nozzleadmittances.AIAA Journal, 1973
- In-Duct Investigation of Subsonic Fan “Rotor Alone” NoiseThe Journal of the Acoustical Society of America, 1972
- Energy Flow Criteria for Acoustic Propagation in Ducts with FlowThe Journal of the Acoustical Society of America, 1971