Impact of resist shrinkage on the template release process in nanoimprint lithography
- 1 November 2014
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 32 (6)
Abstract
Template release in nanoimprint lithography was computationally studied. The impact of resist shrinkage on template release load is described. The resist shrinkage affects the state of the boundary status between resist and template, and is a factor that influences whether the resist adheres to or separates from the template. When the resist fully adheres to the template, the release load increases due to residual stress as the residual layer becomes thinner. This is because compressive stress at the residual layer is induced by resist shrinkage in the pattern cavity. In addition, the release load increases when the resist partially adheres to the template, a consequence of the decrease in interfacial area. This is because the decrement of interface area due to concentration of stress.Keywords
This publication has 23 references indexed in Scilit:
- Simulation study on the template release mechanism and damage estimation for various release methods in nanoimprint lithographyJournal of Vacuum Science & Technology B, 2013
- Simultaneous analysis of residual stress and stress intensity factor in a resist after UV-nanoimprint lithography based on electron moiré fringesJournal of Micromechanics and Microengineering, 2012
- A Simulation Study on the Effect of Cross-Linking Agent Concentration for Defect Tolerant Demolding in UV Nanoimprint LithographyLangmuir, 2012
- Surface adhesion and demolding force dependence on resist composition in ultraviolet nanoimprint lithographyApplied Surface Science, 2011
- Polymerization shrinkage stress measurement for a UV-curable resist in nanoimprint lithographyJournal of Micromechanics and Microengineering, 2011
- A razor-blade test of the demolding energy in a thermoplastic embossing processJournal of Micromechanics and Microengineering, 2011
- Demolding temperature in thermal nanoimprint lithographyApplied Physics A, 2009
- Analysis of the Residual Stresses in the Process of Nanoimprint LithographyInternational Polymer Processing, 2006
- Defect analysis in thermal nanoimprint lithographyJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2003
- Characterization and modeling of volumetric and mechanical properties for step and flash imprint lithography photopolymersJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2001