Carbon Formation in the Reforming of Simulated Biomass Gasification Gas on Nickel and Rhodium Catalysts
Open Access
Abstract
Biomass gasification gas contains hydrocarbons that must be converted to CO and H2 prior to the utilization of the gas in a synthesis unit. Autothermal or steam reforming operating with a nickel or noble metal catalyst is a feasible option to treat the gas, but the harsh reaction conditions may lead to the formation of solid carbon. This study discusses the effects of pressure, time-on-stream, and ethylene content on the carbon formation on nickel and rhodium catalysts. The experiments were carried out with laboratory-scale equipment using reaction conditions that were closely simulated after a pilot-scale biomass gasifier. The results indicated that ethylene content above 20,000 vol-ppm and the increased pressure would increase the carbon formation, although there were differences between the rhodium and nickel catalysts. However, carbon formation was significantly more pronounced on the nickel catalyst when the reaction time was increased from 5 h to 144 h. The type of carbon was found to be primarily encapsulating and graphitic. The formation of whisker carbons (also known as carbon nanotubes) was not observed, which is consistent with the literature as the feed gas contained H2S. It was concluded that utilizing a noble metal catalyst as the front layer of the catalyst bed could lower the risk for carbon formation sufficiently to provide stable long-term operation.Keywords
Funding Information
- European Commission (727476)
- Tekes (238/31/11, 40441/11)
This publication has 62 references indexed in Scilit:
- Application of Fischer–Tropsch Synthesis in Biomass to Liquid ConversionCatalysts, 2012
- Naphthalene steam reforming over Mn-doped CeO2–ZrO2 supported nickel catalystsApplied Catalysis A: General, 2010
- Experimental investigation of the catalytic cracking of methane over a supported Ni catalystThe Canadian Journal of Chemical Engineering, 2009
- Effect of preparation method on structural characteristics and propane steam reforming performance of Ni–Al2O3 catalystsJournal of Molecular Catalysis A: Chemical, 2009
- Detailed chemical kinetic modeling of pyrolysis of ethylene, acetylene, and propylene at 1073–1373 K with a plug‐flow reactor modelInternational Journal of Chemical Kinetics, 2008
- Analysis of gas phase compounds in chemical vapor deposition of carbon from light hydrocarbonsCarbon, 2006
- Experience with raw gas analysis from pressurized gasification of biomassBiomass and Bioenergy, 2000
- Deactivation of steam-reforming model catalysts by coke formation I. Kinetics of the Formation of Filamentous Carbon in the Hydrogenolysis of cyclopentane on Ni/Al2O3 CatalystsJournal of Catalysis, 1990
- Statistical models for ensemble control by alloying and poisoning of catalysts I. Mathematical assumptions and derivationsJournal of Catalysis, 1987
- Carbonaceous deposition associated with the catalytic steam-reforming of hydrocarbons over nickel alumina catalystsJournal of Catalysis, 1981