Metallurgical Parameters Controlling the Eutectic Silicon Charateristics in Be-Treated Al-Si-Mg Alloys
Open Access
Abstract
The present work was carried out on Al-7%Si-0.4%Mg-X alloy (where X = Mg, Fe, Sr or Be), where the effect of solidification rate on the eutectic silicon characteristics was investigated. Two solidification rates corresponding to dendrite arm spacings (DAS) of 24 and 65 μm were employed. Samples with 24 μm DAS were solution heat-treated at 540 °C for 5 and 12 h prior to quenching in warm water at 65 °C. Eutectic Si particle charateristics were measured using an image analyzer. The results show that the addition of 0.05% Be leads to partial modification of the Si particles. Full modification was only obtained when Sr was added in an amount of 150–200 ppm, depending on the applied solidification rate. Increasing the amount of Mg to 0.8% in Sr-modified alloys leads to a reduction in the effectiveness of Sr as the main modifier. Similar observations were made when the Fe content was increased in Be-treated alloys due to the Be-Fe interaction. Over-modification results in the precipitation of hard Sr-rich particles, mainly Al4SrSi2, whereas overheating causes incipient melting of the Al-Cu eutectic and hence the surrounding matrix. Both factors lead to a deterioration in the alloy mechanical properties. Furthermore, the presence of long, acicular Si particles accelerates the occurrence of fracture and, as a result, yields poor ductility. In low iron (less than 0.1 wt%) Al-Si-Mg alloys, the mechanical properties in the as cast, as well as heat treated conditions, are mainly controlled by the eutectic Si charatersitics. Increasing the iron content and, hence, the volume fraction of Fe-based intermetallics leads to a complex fracture mode.Keywords
This publication has 16 references indexed in Scilit:
- Optimizing the tensile properties of Al–Si–Cu–Mg 319-type alloys: Role of solution heat treatmentMaterials & Design (1980-2015), 2014
- Intermetallic phases in Al–Si based cast alloys: new perspectiveInternational Journal of Cast Metals Research, 2013
- Microstructure of Al4Sr Phase in Al-Sr Master Alloy and its Effect on Modification PropertiesProcedia Engineering, 2012
- Fracture Surface Facets and Fatigue Life Potential of CastingsMetallurgical and Materials Transactions B, 2011
- Effect of Strontium and Phosphorus on Eutectic Al-Si Nucleation and Formation of β-Al5FeSi in Hypoeutectic Al-Si Foundry AlloysMetallurgical and Materials Transactions A, 2008
- An overview of the effects of bifilms on the structure and properties of cast alloysMetallurgical and Materials Transactions B, 2006
- Improvement of 319 aluminum alloy casting durability by high temperature solution treatmentJournal of Materials Processing Technology, 2001
- The effect of Mg on the microstructure and mechanical behavior of Al-Si-Mg casting alloysMetallurgical and Materials Transactions A, 1999
- The formation of β-FeSiAl5 and BeFe phases in Al7Si0.3Mg alloy containing BeMaterials Science and Engineering: A, 1995
- Effect of melt cleanliness on the properties of an Al-10 Wt Pct Si-10 Vol Pct SiC(p) CompositeMetallurgical Transactions A, 1993