Influence of sliding speed on modes of material transfer as steel slides against PVD tool coatings
Authors:
- J. HeinrichsJHJ. Heinrichs
- J. GerthJGJ. Gerth
- T. ThersleffTTT. Thersleff
- U. BexellUBU. Bexell
- M. LarssonMLM. Larsson
- U. WiklundUWU. Wiklund
- 1 February 2013
- journal article
- Published by Elsevier in Tribology International
- Vol. 58, 55-64
Abstract
No abstract availableKeywords
This publication has 15 references indexed in Scilit:
- Evaluation of an intermittent sliding test for reproducing work material transfer in milling operationsTribology International, 2012
- Reproducing wear mechanisms in gear hobbing—Evaluation of a single insert milling testWear, 2009
- On the wear of PVD-coated HSS hobs in dry gear cuttingWear, 2009
- Wear progressions and tool life enhancement with AlCrN coated inserts in high-speed dry and wet steel lathingWear, 2008
- Modern coatings in high performance cutting applicationsInternational Journal of Refractory Metals and Hard Materials, 2006
- Formation of a transfer layer at the tool-chip interface during machiningWear, 2000
- Influence of Tin Coating on Wear of High Speed Steel Tools as Studied by New Laboratory Wear TestSurface Engineering, 1989
- The effect of a non-metallic material deposit in decreasing the wear of TiN-coated high speed steel cutting toolsWear, 1984
- The adhesion mechanism of the built-up edge and the layer on the rake face of a cutting toolWear, 1978
- Layer formation on the rake face of a cutting tool and its effect on tool lifeWear, 1976