Influence of Barium Incorporation on the Electrochemical Performance of Ln0.58Sr0.4Fe0.8Co0.2O3–δ(Ln=La, Pr, Sm) Perovskites for Oxygen Activation at Intermediate Temperatures
- 29 September 2009
- journal article
- research article
- Published by Wiley in Fuel Cells
- Vol. 9 (5) , 663-678
Abstract
Highly active perovskite‐based electrodes were obtained through partial substitution of lanthanides (La, Pr and Sm) by barium in the Ln0.58Sr0.4Fe0.8Co0.2O3system. These compositions were obtained as single phase crystalline compounds through a sol–gel synthetic route and tested by electrochemical impedance spectroscopy (EIS) as symmetrical cells on GDC‐electrolyte samples in the temperature range 450–650 °C. Cooperative effects arose through the incorporation of a large divalent active cation (Ba+2) in the perovskite lattice of lanthanide‐based strontium ferrites‐cobaltites. Reduction in the electrode polarisation resistance with respect to non‐substituted compositions is obtained irrespective of the amount of barium substitution and lanthanide nature. Barium addition also reduces the activation energy of these compositions, indicating changes in the oxygen activation processes. The specific effect of the barium incorporation on the electrode performance was dependent on the nature of the partially substituted lanthanide. Lanthanum–barium‐based compositions exhibited the lowest electrode polarisation resistance when the amount of the replaced barium was increased up to 50% molar. On the other hand, for praseodymium‐ or samarium–barium‐based compositions, the minimum in electrode polarisation resistance was achieved at barium substitutions close to 25% molar. The study of the effect of oxygen partial pressure on EIS data allowed in improving the understanding of the processes governing the electrode operation.Keywords
This publication has 39 references indexed in Scilit:
- Electrode materials and reaction mechanisms in solid oxide fuel cells: a brief reviewJournal of Solid State Electrochemistry, 2008
- On the nanostructuring and catalytic promotion of intermediate temperature solid oxide fuel cell (IT-SOFC) cathodesJournal of Power Sources, 2007
- Preparation and characterization of Pr1−xSrxFeO3 cathode material for intermediate temperature solid oxide fuel cellsJournal of Power Sources, 2007
- Performance of XSCoF (X=Ba, La and Sm) and LSCrX′ (X′=Mn, Fe and Al) perovskite-structure materials on LSGM electrolyte for IT-SOFCElectrochimica Acta, 2007
- Ferrite-based perovskites as cathode materials for anode-supported solid oxide fuel cellsSolid State Ionics, 2005
- Electrochemical Characterization of La[sub 0.6]Sr[sub 0.4]Co[sub 0.2]Fe[sub 0.8]O[sub 3] Cathodes for Intermediate-Temperature SOFCsJournal of the Electrochemical Society, 2004
- Sm0.5Sr0.5CoO3 cathodes for low-temperature SOFCsSolid State Ionics, 2002
- Surface modification of La(Sr)MnO3 electrodesSolid State Ionics, 1998
- Perovskite-type oxides as oxygen electrodes for high temperature oxide fuel cellsSolid State Ionics, 1987
- Cathode Materials and Performance in High-Temperature Zirconia Electrolyte Fuel CellsJournal of the Electrochemical Society, 1969