Measurement and modeling of two-phase flow parameters in scaled 8×8 BWR rod bundle
Authors:
- X. YangXYX. Yang
- J.P. SchlegelJSJ.P. Schlegel
- Y. LiuYLY. Liu
- S. ParanjapeSPS. Paranjape
- T. HibikiTHT. Hibiki
- M. IshiiMIM. Ishii
- 1 April 2012
- journal article
- Published by Elsevier in International Journal of Heat and Fluid Flow
- Vol. 34, 85-97
Abstract
No abstract availableKeywords
This publication has 21 references indexed in Scilit:
- Drift-flux model in a sub-channel of rod bundle geometryInternational Journal of Heat and Mass Transfer, 2009
- Interfacial Area Transport Equations for Gas-Liquid FlowThe Journal of Computational Multiphase Flows, 2009
- Pressure Drop Characteristics in Tight-Lattice Bundles for Reduced-Moderation Water ReactorsJSME International Journal Series B, 2004
- An experimental study and assessment of existing friction factor correlations for wire-wrapped fuel assembliesAnnals of Nuclear Energy, 2001
- Development of the miniaturized four-sensor conductivity probe and the signal processing schemeInternational Journal of Heat and Mass Transfer, 2000
- Drift flux model for large diameter pipe and new correlation for pool void fractionInternational Journal of Heat and Mass Transfer, 1987
- Flow regime transition criteria for upward two-phase flow in vertical tubesInternational Journal of Heat and Mass Transfer, 1984
- A theoretical basis for the Lockhart-Martinelli correlation for two-phase flowInternational Journal of Heat and Mass Transfer, 1967
- Average Volumetric Concentration in Two-Phase Flow SystemsJournal of Heat Transfer, 1965
- A high resolution resistivity probe for determination of local void properties in gas‐liquid flowAIChE Journal, 1963