PDMS Microcantilever-Based Flow Sensor Integration for Lab-on-a-Chip
Authors:
- 9 October 2012
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 13 (2) , 601-609
Abstract
In this paper, a simple practical method is presented to fabricate a high aspect ratio horizontal polydimethylsiloxane (PDMS) microcantilever-based flow sensor integrated into a microfluidic device. A multilayer soft lithography process is developed to fabricate a thin PDMS layer involving the PDMS microcantilever and the microfluidics network. A three-layer fabrication technique is explored for the integration of the microflow meter. The upper and lower PDMS layers are bonded to the thin layer to release the microcantilever for free deflection. A 3-D finite element analysis is carried out to simulate fluid-structure interaction and estimate cantilever deflection under various flow conditions. The dynamic range of flow rates that is detectable using the flow sensor is assessed by both simulation and experimental methods and compared. Limited by the accuracy of the 1.76- μm resolution of the image acquisition method, the present setup allows for flow rates as low as 35 μL/min to be detected. This is equal to 0.8-μN resolution in equivalent force at the tip. This flow meter can be integrated into any type of microfluidic-based lab-on-a-chip in which flow measurement is crucial, such as flow cytometry and particle separation applications.Keywords
This publication has 26 references indexed in Scilit:
- Poly(dimethyl siloxane) surface modification by low pressure plasma to improve its characteristics towards biomedical applicationsColloids and Surfaces B: Biointerfaces, 2010
- Nanonewton Force Sensing and Control in Microrobotic Cell ManipulationThe International Journal of Robotics Research, 2009
- Viscoelastic mechanical behavior of soft microcantilever-based force sensorsApplied Physics Letters, 2008
- Design and microfabrication of a high-aspect-ratio PDMS microbeam array for parallel nanonewton force measurement and protein printingJournal of Micromechanics and Microengineering, 2007
- Hydrodynamic loading of microcantilevers vibrating in viscous fluidsJournal of Applied Physics, 2006
- Vision-based force measurementIEEE Transactions on Pattern Analysis and Machine Intelligence, 2004
- Cells lying on a bed of microneedles: An approach to isolate mechanical forceProceedings of the National Academy of Sciences, 2003
- Simulation and optimization of a microfluidic flow sensorSensors and Actuators A: Physical, 2001
- Thermal flow sensor for liquids and gases based on combinations of two principlesSensors and Actuators A: Physical, 1999
- The mechanical properties of the rubber elastic polymer polydimethylsiloxane for sensor applicationsJournal of Micromechanics and Microengineering, 1997