The Effect of a Number of Baffles on the Performance of Shell-and-Tube Heat Exchangers
- 22 December 2017
- journal article
- research article
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 40 (1-2) , 39-52
Abstract
The number of baffles has an impact on the thermal-hydraulic performance of a shell-and-tube heat exchanger (STHX), thus a model was developed using Engineering Equations Solver software to solve the governing equations. The program uses Kern, Bell-Delaware, and flow-stream analysis (Wills Johnston) methods to predict both the heat-transfer coefficient and pressure drop on the shell side of an STHX. It was found that Bell-Delaware method is the most accurate method when compared with the experimental results. The effect of a number of baffles, mass flow rate, tube layout, fluid properties and baffle cut were investigated. The analysis revealed that an increase in the number of baffles increases both the heat-transfer coefficient and pressure drop on the shell-side. Increasing the mass flow rate, the heat transfer coefficient increases; however, the pressure drop increases at a higher rate. For a large number of baffles, the pressure drop decreases with an increase in the baffle cut. It also shows that the heat transfer coefficient increases at a higher rate with the square tube layout, whereas the rotated square and triangular layouts have approximately the same behavior.Keywords
This publication has 7 references indexed in Scilit:
- Performance of Shell and Tube Heat Exchangers with Varying Tube LayoutsBritish Journal of Applied Science & Technology, 2016
- Flow Analysis in Shell Side on the Effect of Baffle Spacing of Shell and Tube Heat ExchangerInternational Journal of Science, Technology and Society, 2015
- Effect of segmental baffles on the shell-and-tube heat exchanger effectiveness2014
- Numerical Investigation of the Effect of Baffle Orientation on Heat Transfer and Pressure Drop in a Shell and Tube Heat Exchanger With Leakage FlowsHeat Transfer Engineering, 2009
- Effect of baffle spacing on pressure drop and local heat transfer in shell-and-tube heat exchangers for staggered tube arrangementInternational Journal of Heat and Mass Transfer, 1998
- Pressure drop on the shell side of shell-and-tube heat exchangers with segmental bafflesChemical Engineering and Processing - Process Intensification, 1997
- Influence of a Finite Number of Baffles on Shell-and-Tube Heat Exchanger PerformanceHeat Transfer Engineering, 1997