Biomaterials for orthopedics: A roughness analysis by atomic force microscopy
- 26 February 2007
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part A
- Vol. 82A (3) , 723-730
Abstract
We conducted an AFM analysis of roughness on 7 materials widely used in bone reconstruction. Roughness was evaluated by measuring Root Mean Square (RMS) values and RMS/average height (AH) ratio, in different dimensional ranges, varying from 100 microns square to a few hundreds of nanometers. The results showed that Titanium presented a lower roughness than the other materials analyzed, frequently reaching statistical significance. On the contrary, bioactive materials, such as hydroxyapatite (HA) and bioactive glasses, demonstrated an overall higher roughness. In particular, this study focuses attention on AP40 and especially RKKP, which proved to have a significant higher roughness at low dimensional ranges. This determines a large increase in surface area, which is strongly connected with osteoblast adhesion and growth and to protein absorption. Therefore, the biointegration properties of bioactive glasses can also be given as answer in terms of surface structures in which chemical composition can influence directly the biological system (e.g. with chemical exchanges and development of specific surface electrical charge) and indirectly, via the properties induced on tribological behavior that expresses itself during the smoothing of the surfaces. We also test two new bioactive glasses, RBP1 and RBP2, with a chemical composition similar to AP40, but with some significant small additions and substitutions of components, in order to make preliminary considerations on their potential role in orthopedics. © 2007 Wiley Periodicals, Inc. J Biomed Mater Res 2007Keywords
This publication has 37 references indexed in Scilit:
- Increased osteoblast functions on undoped and yttrium-doped nanocrystalline hydroxyapatite coatings on titaniumBiomaterials, 2006
- Fabrication, characterization, and biological assessment of multilayered DNA-coatings for biomaterial purposesBiomaterials, 2006
- Osteointegration of bioactive glass‐coated and uncoated zirconia in osteopenic bone: An in vivo experimental studyJournal of Biomedical Materials Research Part A, 2003
- Biocompatibility and osseointegration in osteoporotic boneThe Journal of Bone and Joint Surgery. British volume, 2001
- Controlled-atmosphere chamber for atomic force microscopy investigationsReview of Scientific Instruments, 2000
- Osseo-mechanical induction of extra-cortical plates with reference to their surface properties and geometric designsBiomaterials, 1999
- Characterization of silicon transducers with Si3N4 sensing surfaces by an AFM and a PAB systemSensors and Actuators B: Chemical, 1995
- Structural modifications and biological compatibility of doped bio-active glassesBiomaterials, 1988
- Interpretation of difficulties in the initial adhesion of bio-active glasses to boneBiomaterials, 1988
- Bonding mechanisms at the interface of ceramic prosthetic materialsJournal of Biomedical Materials Research, 1971