An investigation on co-axial water-jet assisted fiber laser cutting of metal sheets
Authors:
- Yuvraj K. MadhukarYMYuvraj K. Madhukar
- Suvradip MullickSMSuvradip Mullick
- Ashish K. NathANAshish K. Nath
- 1 February 2016
- journal article
- Published by Elsevier in Optics and Lasers in Engineering
- Vol. 77, 203-218
Abstract
No abstract availableKeywords
Funding Information
- Department of Science and Technology
- Board of Research on Nuclear Science (BRNS)
- Department of Mechanical Engineering
This publication has 25 references indexed in Scilit:
- Effect of laser operating mode in paint removal with a fiber laserApplied Surface Science, 2013
- Comparison of dry and wet fibre laser profile cutting of thin 316L stainless steel tubes for medical device applicationsJournal of Materials Processing Technology, 2010
- Optimization of titanium cutting by factorial analysis of the pulsed Nd:YAG laser parametersJournal of Materials Processing Technology, 2006
- Friction stir welding of ultrafine grained plain low-carbon steel formed by the martensite processMaterials Science and Engineering: A, 2006
- Dross formation during laser cutting processJournal of Physics D: Applied Physics, 2006
- Influence of process parameters during pulsed Nd:YAG laser cutting of nickel-base superalloysJournal of Materials Processing Technology, 2005
- Cutting of 1.2mm thick austenitic stainless steel sheet using pulsed and CW Nd:YAG laserJournal of Materials Processing Technology, 2005
- CO2 laser cut quality of 4130 steelInternational Journal of Machine Tools and Manufacture, 2003
- Analysis of heat-affected zone formation for laser cutting of stainless steelJournal of Materials Processing Technology, 1995
- The viscosity of liquid metals and alloysActa Metallurgica, 1989