Ground experimentation with 3D printed scramjet inlet models at hypervelocities
Authors:
- I.S. RêgoIRI.S. Rêgo
- T.V.C. MarcosTMT.V.C. Marcos
- D. Romanelli PintoDPD. Romanelli Pinto
- R.G.S. VilelaRVR.G.S. Vilela
- V.A.B. GalvãoVGV.A.B. Galvão
- A. PivettaAPA. Pivetta
- G.P. CamiloGCG.P. Camilo
- J.R.T. SilvaJSJ.R.T. Silva
- B.C. LimaBLB.C. Lima
- A.K. CarvalhalACA.K. Carvalhal
- R.L. CardosoRCR.L. Cardoso
- J.F.A. MartosJMJ.F.A. Martos
- 1 August 2016
- journal article
- Published by Elsevier in Aerospace Science and Technology
- Vol. 55, 307-313
Abstract
No abstract availableFunding Information
- FINEP (01.11.0156.01, 01.08.0365.00)
This publication has 7 references indexed in Scilit:
- A preliminary design and manufacturing study of hybrid lightweight high‐speed wind‐tunnel modelsRapid Prototyping Journal, 2011
- Experimental results of a Mach 10 conical-flow derived waverider to 14-X hypersonic airspace vehicleJournal of Aerospace Technology and Management, 2011
- Advances in three dimensional printing – state of the art and future perspectivesRapid Prototyping Journal, 2006
- Rapid Technique for Wind-Tunnel Model ManufactureJournal of Aircraft, 2004
- A comparison of rapid prototyping techniques used for wind tunnel model fabricationRapid Prototyping Journal, 1998
- Evaluating Aerodynamic Characteristics of Wind-Tunnel Models Produced by Rapid Prototyping MethodsJournal of Spacecraft and Rockets, 1998
- Boundary-layer transition on a 10 deg cone in hypersonic flows.AIAA Journal, 1965