Microstructure Effects on the Machinability of AM-Produced Superalloys
Authors:
Open Access
Abstract
This paper discusses the microstructure effects on the machinability of Inconel 718 by conducting machining tests on an additively manufactured (AM) workpiece with a strongly textured grain structure and a wrought workpiece incorporating a finer and more equiaxed grain structure. The AM workpiece was produced as a thin tube using Laser Melting Powder Bed Fusion and optimal processing conditions for this alloy. A lathe was used to conduct instrumented orthogonal machining tests on the two workpiece materials under dry cut and coolant conditions using a semisynthetic emulsion coolant. The process parameters studied were feed from 0.05 to 0.15 mm/rev and cutting speed from 60 to 120 m/min with a cut time of 2 sec duration for each process condition. Measures for each process condition included cutting forces in the feed and main cut direction, and images of chip forms were obtained. The grain structures of the workpiece materials were characterized using Electron Back Scattered Diffraction (EBSD). New findings suggest that grain structures can significantly affect the machinability of the superalloy at a higher feed for all cutting speeds studied, and insights into the cause are discussed. Other important findings comment on the effectiveness of the coolant as a lubricant for reducing friction in machining.Keywords
Funding Information
- MCIN/AEI/10.13039/501100011033 (PID2020-112628RA-I00, PID2020-118480RB-C2)
This publication has 30 references indexed in Scilit:
- Adiabatic shear banding and scaling laws in chip formation with application to cutting of Ti–6Al–4VJournal of the Mechanics and Physics of Solids, 2013
- Analysis of adiabatic shear banding in orthogonal cutting of Ti alloyInternational Journal of Mechanical Sciences, 2013
- The effect of temperature on wear and friction of a high strength steel in frettingWear, 2013
- The microstructure and mechanical properties of deposited-IN718 by selective laser meltingJournal of Alloys and Compounds, 2012
- New observations on tool life, cutting forces and chip morphology in cryogenic machining Ti-6Al-4VInternational Journal of Machine Tools and Manufacture, 2011
- Key improvements in the machining of difficult-to-cut aerospace superalloysInternational Journal of Machine Tools and Manufacture, 2005
- An overview of the machinability of aeroengine alloysJournal of Materials Processing Technology, 2003
- The machinability of nickel-based alloys: a reviewJournal of Materials Processing Technology, 1999
- The machinability of inconel 718Journal of Materials Processing Technology, 1997
- Catastrophic Thermoplastic ShearJournal of Applied Mechanics, 1964