The Optimisation Analysis of Sand-Clay Mixtures Stabilised with Xanthan Gum Biopolymers
Open Access
- 26 March 2021
- journal article
- research article
- Published by MDPI AG in Sustainability
- Vol. 13 (7) , 3732
Abstract
Sand–clay mixtures can be encountered in both natural soils (e.g., residual soils, clay deposits and clinosols) and artificial fills. The method of utilising biopolymers in ground improvement for sand–clay mixtures has emerged recently. However, a full understanding of the strengthening effect of biopolymer-treated sand–clay mixtures has not yet been achieved due to a limited number of relevant studies. In this study, xanthan gum (XG), as one of the eco-friendly biopolymers, was used to treat reconstituted sand–clay mixtures that had various compositions in related to clay (or sand) content and clay type (kaolin and bentonite). A series of laboratory unconfined compression strength (UCS) tests were conducted to probe the performances of XG-treated sand–clay mixtures from two aspects, i.e., optimum treatment conditions (e.g., XG content and initial moisture content) to achieve the maximum strengthening effect and strengthening efficiency for the sand–clay mixtures with different compositions. The experimental results indicated that the optimum initial moisture content decreased as the sand content increased. The optimum XG content, which also decreased with the increasing sand content, remained approximately 3.75% for all sand–kaolin mixtures and 5.75% for all sand–bentonite mixtures if calculated based on clay fraction. While untreated sand–kaolin mixtures and sand–bentonite mixtures had comparable UCS values, XG-treated sand–kaolin mixtures seemed to have better improved mechanical strength due to higher ionic (or hydrogen) bonds with XG and low-swelling properties compared with bentonite. The deformation modulus of XG-treated sand–clay mixtures were positively related with UCS. The variation in UCS and stiffness for each treatment condition increased as the sand content was elevated for both sand-kaolin and sand-bentonite mixtures. An increment in the proportion of the heterogeneous composite formed by irregular sand particles conglomerated with the XG–clay matrix in total soil might be responsible for this phenomenon.Keywords
All Related Versions
Funding Information
- European Union's Horizon 2020 Framework programme Marie Skłodowska-Curie Individual Fellowships under grant agreement (897701)
- Marie Skłodowska-Curie Actions Research and Innovation Staff Exchange (RISE) under grant agreement (778360)
- National Natural Science Foundation of China (51608323, 51678319, 51978533)
This publication has 78 references indexed in Scilit:
- Microbiological induced carbonate (CaCO3) precipitation using clay phyllites to replace chemical stabilizers (cement or lime)Applied Clay Science, 2019
- A large-strain radial consolidation theory for soft clays improved by vertical drainsGéotechnique, 2017
- Development of sustainable masonry units from flood mud soil: Strength and morphology investigationsConstruction and Building Materials, 2017
- Geotechnical engineering behaviors of gellan gum biopolymer treated sandCanadian Geotechnical Journal, 2016
- Xanthan gum biopolymer: an eco-friendly additive for stabilization of tropical organic peatEnvironmental Earth Sciences, 2016
- Introduction of Microbial Biopolymers in Soil Treatment for Future Environmentally-Friendly and Sustainable Geotechnical EngineeringSustainability, 2016
- Micro-structural analysis of strength development in low- and high swelling clays stabilized with magnesium chloride solution — A green soil stabilizerApplied Clay Science, 2015
- Strength properties of an epoxy resin and cement-stabilized silty clay soilApplied Clay Science, 2015
- Consolidation analysis of clayey deposits under vacuum pressure with horizontal drainsGeotextiles and Geomembranes, 2014
- The mechanics of fibre-reinforced sandGéotechnique, 2010