Multi-Step Loading Creep Behavior of Red Sandstone after Thermal Treatments and a Creep Damage Model
Open Access
Abstract
Triaxial compressive creep tests were conducted on red sandstones after different thermal treatments. Subsequently, the thermal influence on the axial, lateral and volumetric creep curves under various stress levels was analyzed. The results show that both the instantaneous and time-based deformation behaviors depended largely on the stress and temperature conditions. The instant axial strain increases linearly with increasing deviator stress and the instant deformation modulus decreases non-linearly with temperature. An interesting phenomenon was observed whereby the lateral creep strain had an apparent linear correlation with the axial creep strain. Furthermore, the fitting lines’ slopes of lateral and axial creep strain increase gradually with the increasing deviator stress at identical temperature and first decreases and then increases as temperature is elevated. Then, on the basis of the Burgers creep model and the concept of strain energy, a creep damage model implemented in FLAC3D (Fast Lagrangian Analysis of Continua 3D) is presented, and this model was able to describe the entire creep process completely including primary creep stage, secondary creep stage, and tertiary creep stage comparing with the experimental and theoretical results based on test data and numerical calculations. The influence of two damage parameters on creep curves and the thermal influence on creep parameters are subsequently discussed. Under the same stress level, the parameters K, GM and GK and ηK of creep model decrease with temperature, while the parameter ηM first augments as temperature rise to 300 °C and then decreases as temperature at above 300 °C. The higher is the temperature, the smaller the critical stress ratio (CSR).Keywords
This publication has 56 references indexed in Scilit:
- A thermodynamic framework for constitutive modeling of time- and rate-dependent materials. Part I: TheoryInternational Journal of Plasticity, 2012
- Physical Properties of Sandstones After High Temperature TreatmentRock Mechanics and Rock Engineering, 2012
- Influence of temperature on brittle creep in sandstonesGeophysical Research Letters, 2009
- Experimental Studies on the Mechanical Behaviour of two Thermal Cracked MarblesRock Mechanics and Rock Engineering, 2001
- Structural stability of andesite volcanoes and lava domesPhilosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2000
- High-temperature transient creep in olivine rocksTectonophysics, 1997
- Rheology of rocksaltJournal of Structural Geology, 1993
- A Micromechanics-Based Model for Creep Behavior of RockApplied Mechanics Reviews, 1992
- High-temperature creep of Mt. Burnet DuniteTectonophysics, 1977
- Laboratory observations of high-temperature rheology of rocksTectonophysics, 1972