Dynamic Behavior of Structure-mounted Disk-shape Piezoelectric Sensors Including the Adhesive Layer
Author:
- 12 May 2009
- journal article
- Published by SAGE Publications in Journal of Intelligent Material Systems and Structures
- Vol. 20 (13) , 1553-1564
Abstract
Piezoelectric (PZT) transducers are commonly used for numerous diagnostic techniques for nondestructive evaluation (NDE) of structures. Researchers in the past have shown that the presence of an adhesive layer between the PZT patch and the structure could have a significant impact both on the amplitude of the wave propagated into the structure and on its Electromechanical impedance (EMI) signature. To account for losses, models have been developed to describe the effects of the adhesive layer. Nonetheless, the models found in the literature are strictly valid for either 1D or rectangular PZT patches only. The aim of this article is to develop a dynamic model for a disk, PZT patch connected to a structure by means of a thin adhesive layer. Unlike previous works, it was found that for disk-shape sensors the effect of the adhesive layer is frequency dependent and that the losses due to the shear deformation of the adhesive layer for the case near the first radial resonant mode were considerably lower than for the quasi-static case. In order to validate the model developed in this article, experimental data are compared to the predicted EMI signatures of disk-shape sensors mounted on a structure for various configurations.Keywords
This publication has 13 references indexed in Scilit:
- An electromechanical impedance model of a piezoceramic transducer-structure in the presence of thick adhesive bondingSmart Materials and Structures, 2007
- Three-Dimensional Electromechanical Impedance Model. I: Formulation of Directional Sum ImpedanceJournal of Aerospace Engineering, 2007
- Performance assessment and validation of piezoelectric active-sensors in structural health monitoringSmart Materials and Structures, 2006
- Electromechanical Impedance Modeling for Adhesively Bonded Piezo-TransducersJournal of Intelligent Material Systems and Structures, 2004
- Piezoelectric Wafer Embedded Active Sensors for Aging Aircraft Structural Health MonitoringStructural Health Monitoring, 2002
- Electro-Mechanical Impedance Method for Crack Detection in Thin PlatesJournal of Intelligent Material Systems and Structures, 2001
- Impedance-Based Structural Health Monitoring with Artificial Neural NetworksJournal of Intelligent Material Systems and Structures, 2000
- Coupled Electro-Mechanical Analysis of Adaptive Material Systems — Determination of the Actuator Power Consumption and System Energy TransferJournal of Intelligent Material Systems and Structures, 1994
- Use of piezoelectric actuators as elements of intelligent structuresAIAA Journal, 1987
- Properties of n-Butyl-α-Cyanoacrylate MixturesJournal of Dental Research, 1969