Glass formation in a (Ti, Zr, Hf)–(Cu, Ni, Ag)–Al high-order alloy system by mechanical alloying
- 1 September 2003
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 18 (9) , 2141-2149
Abstract
In this work, glass formation under high-energy ball milling was investigated for a (Ti0.33Zr0.33Hf0.33)50(Ni0.33Cu0.33Ag0.33)40Al10 high-order alloy system with equiatomic substitution for early and late transition-metal contents. For comparison, an amorphous alloy ribbon with the same composition was prepared using the melt-spinning method as well. Structural features of the samples were characterized using x-ray diffraction, transmission electron microscopy, and differential scanning calorimetry. Mechanical alloying resulted in a glassy alloy similar to that obtained by melt spinning. However, the glass formation was incomplete, and a small amount of unreacted crystallites smaller than 30 nm in size still remained in the final ball-milled product. Like the melt-spun glass, the ball-milled glassy alloy also exhibited a distinct glass transition and a wide supercooled liquid region of about 80 K. Crystallization of this high-order glassy alloy proceeded through two main stages. After the primary nanocrystallization was completed, the remaining amorphous phase also behaved as a glass, showing a detectable glass transition and a large supercooled liquid region of about 100 K.Keywords
This publication has 56 references indexed in Scilit:
- Formation of Glassy Ti50Cu20Ni24Si4B2 Alloy by High-Energy Ball MillingMaterials Science Forum, 2002
- “Big cube” phase formation in Zr-based metallic glassesMaterials Science and Engineering: A, 2001
- Evaluation of the Volume Fraction Crystallised during Devitrification of Al-Based Amorphous AlloysMaterials Science Forum, 2000
- Glass formation in a ZrAlNiCuCo alloy by ball milling of an intermetallic phase mixtureMaterials Letters, 1997
- Synthesis of multicomponent Fe-based amorphous alloys with significant supercooled liquid region by mechanical alloyingMaterials Science and Engineering: A, 1997
- Structural study of Zr33Y27Al15Ni25 amorphous alloys by anomalous X-ray scattering (AXS)Materials Science and Engineering: A, 1994
- ZrY base amorphous alloys with two glass transitions and two supercooled liquid regionsMaterials Science and Engineering: A, 1994
- Structural comparison of amorphous Cu50Zr50 alloys prepared by proton irradiation, melt spinning, and mechanical alloyingJournal of Applied Physics, 1988
- Calorimetry study of the synthesis of amorphous Ni-Ti alloys by mechanical alloyingJournal of the Less Common Metals, 1988
- Enthalpic and structural studies of the NiZr systemJournal of the Less Common Metals, 1983