Prediction of cutting force, tool wear and surface roughness of Al6061/SiC composite for end milling operations using RSM
- 19 September 2013
- journal article
- research article
- Published by Springer Nature in Journal of Mechanical Science and Technology
- Vol. 27 (9) , 2813-2822
Abstract
No abstract availableKeywords
This publication has 14 references indexed in Scilit:
- Effect of turning parameters on surface roughness of A356/5% SiC composite produced by electromagnetic stir castingJournal of Mechanical Science and Technology, 2012
- Analysis and prediction of tool wear, surface roughness and cutting forces in hard turning with CBN toolJournal of Mechanical Science and Technology, 2012
- Modeling and optimization of hard turning of X38CrMoV5-1 steel with CBN tool: Machining parameters effects on flank wear and surface roughnessJournal of Mechanical Science and Technology, 2011
- Indirect cutting force measurement in the micro end-milling process based on frequency analysis of sensor signalsJournal of Mechanical Science and Technology, 2010
- Analysis of directional factors in milling: importance of multi-frequency calculation and of the inclusion of the effect of the helix angleThe International Journal of Advanced Manufacturing Technology, 2009
- Experimental study of surface integrity during end milling of Al/SiC particulate metal–matrix compositesJournal of Materials Processing Technology, 2008
- Investigation of mechanical and machinability properties of SiC particle reinforced Al-MMCJournal of Materials Processing Technology, 2008
- Development of a cutting tool condition monitoring system for high speed turning operation by vibration and strain analysisThe International Journal of Advanced Manufacturing Technology, 2007
- Prediction of cutting forces in machining of metal matrix compositesInternational Journal of Machine Tools and Manufacture, 2006
- Selection of optimum tool geometry and cutting conditions using a surface roughness prediction model for end millingThe International Journal of Advanced Manufacturing Technology, 2005