Preparation of the Composite Powder Al – B4C by Ball Milling for Cold Spray
Open Access
- 1 June 2021
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1945 (1) , 012033
Abstract
In the work, when ball milling of mixture of aluminum powder (ASD – 1) and boron carbide (F 500) powder in a high-energy planetary mill, composite particles sized from 10 to 100 microns were produced, in the volume of which ultrafine boron carbide particles were distributed in the size range from 0.1 to 20 microns. It is assumed that the use of such particles in the production of coatings by cold gas-dynamic spraying will increase the deposition efficiency and the weight fraction of boron carbide in the coating. An increase in the concentration of carbide particles in the processed powder mixture, under all other conditions being equal, leads to a decrease in the average volume size of the particles. It is noted that in this case, the boron carbide particles behave as a surfactant. The X-ray phase analysis has shown diffraction peaks corresponding only to aluminum and boron carbide, therefore, under the selected milling conditions, the phase composition remain the same as in the original powders.Keywords
This publication has 17 references indexed in Scilit:
- The influence of Al2O3 particle morphology on the coating formation and dry sliding wear behavior of cold sprayed Al–Al2O3 compositesSurface and Coatings Technology, 2015
- Effects of SiC Volume Fraction and Particle Size on the Deposition Behavior and Mechanical Properties of Cold-Sprayed AZ91D/SiCp Composite CoatingsJournal of Thermal Spray Technology, 2013
- Cold Spraying Activation Using an Abrasive AdmixtureJournal of Thermal Spray Technology, 2012
- The influence of Al2O3 reinforcement on the properties of stainless steel cold spray coatingsSurface and Coatings Technology, 2012
- Nanostructured Al-Based Metal Matrix Composite Coating Production by Pulsed Gas Dynamic Spraying ProcessJournal of Thermal Spray Technology, 2011
- Microstructure and mechanical properties of B4C reinforced Al-based matrix composite coatings deposited by CGDS and PGDS processesSurface and Coatings Technology, 2010
- Effect of Ceramic Particle Velocity on Cold Spray Deposition of Metal-Ceramic CoatingsJournal of Thermal Spray Technology, 2010
- Calculation of Particle Parameters for Cold Spraying of Metal-Ceramic MixturesJournal of Thermal Spray Technology, 2009
- Cold spraying of in situ produced TiB2–Cu nanocomposite powdersComposites Science and Technology, 2007
- Specific features of microparticle deformation upon impact on a rigid barrierJournal of Applied Mechanics and Technical Physics, 2000