Understanding Rate-Limiting Mechanisms in LiFePO4 Cathodes for Li-Ion Batteries
Authors:
- 1 January 2011
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 158 (11) , A1185-A1193
Abstract
This work encompasses modeling and experimental work to improve understanding of transport and other resistances for LiFePO4 composite cathodes used in Li-ion batteries. Modeling LiFePO4 active material requires consideration of the carbon coating around the particle, phase-change behavior, and diffusion in only one of the lattice dimensions of the crystal. Physically realistic parameters for the full-cell sandwich model were measured directly in separate experiments where possible. Despite the complexity of solid-state diffusion in this system, we found that a constant diffusion coefficient was generally adequate. The full model was compared to experiments of LiFePO4 cathodes vs. lithium and good agreement was obtained for a range of electrode thicknesses and discharge rates. We found that a distribution of inter-particle contact resistances is needed to obtain this level of agreement if one wishes to keep all model parameters at physically realistic values. The model shows that resistances corresponding to bulk electronic conductivity and even more so, to local inter-particle contact are significant and in need of further optimization for the cells tested.Keywords
This publication has 37 references indexed in Scilit:
- Continuity and performance in composite electrodesJournal of Power Sources, 2010
- Predicting Active Material Utilization in LiFePO[sub 4] Electrodes Using a Multiscale Mathematical ModelJournal of the Electrochemical Society, 2010
- Quantifying tortuosity in porous Li-ion battery materialsJournal of Power Sources, 2009
- Electrochemical properties of carbon-coated LiFePO4 cathode using graphite, carbon black, and acetylene blackElectrochimica Acta, 2006
- Performance of carbon-fiber-containing LiFePO4 cathodes for high-power applicationsJournal of Power Sources, 2006
- Comparison of LiFePO[sub 4] from Different SourcesJournal of the Electrochemical Society, 2005
- Conductivity improvements to spray-produced LiFePO4 by addition of a carbon sourceMaterials Letters, 2004
- The effect of Cr doping on Li ion diffusion in LiFePO4from first principles investigations and Monte Carlo simulationsJournal of Physics: Condensed Matter, 2004
- Local-Probe Studies of Degradation of Composite LiNi[sub 0.8]Co[sub 0.15]Al[sub 0.05]O[sub 2] Cathodes in High-Power Lithium-Ion CellsElectrochemical and Solid-State Letters, 2004
- Shrinking Core Model for the Discharge of a Metal Hydride ElectrodeJournal of the Electrochemical Society, 2000