Novel angular‐independent higher order band‐stop frequency selective surface for X‐band applications
Open Access
- 28 November 2017
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in IET Microwaves, Antennas & Propagation
- Vol. 12 (1) , 15-22
Abstract
A higher order miniaturised band‐stop frequency selective surface (FSS) with angular stability performance for X‐band applications is presented in this study. The miniaturisation has been achieved by incurving the arms of conventional cross dipole shape inside. The unit cell size of FSS is diminished up to 75% compared to cross dipole FSS operating at the same resonant frequencies. Moreover, the presented FSS is designed to exhibit stable angular performance for incident angles up to about 60° for TE‐ and TM‐polarised waves. The maximum relative frequency deviation is 1.28% with respect to different angles of incidence. Although the designed FSS consists of two layers, higher order and sharp roll‐off filter characteristics have been obtained. The simulation of the proposed FSS is performed with the CST MWS. To verify the simulation results, the presented FSS is measured and a good match between the experimental and simulation results are obtained.Keywords
This publication has 24 references indexed in Scilit:
- Slotted ground microstrip antenna with FSS reflector for high‐gain horizontal polarisationElectronics Letters, 2015
- Compact FSS absorber design using resistively loaded quadruple hexagonal loops for bandwidth enhancementElectronics Letters, 2015
- Polarisation independent resistively loaded frequency selective surface absorber with optimum oblique incidence performanceIET Microwaves, Antennas & Propagation, 2014
- A Single-Layer Frequency-Selective Surface for Ultrawideband Electromagnetic ShieldingIEEE Transactions on Electromagnetic Compatibility, 2014
- DESIGN OF SLOTTED GROUND HEXAGONAL MICROSTRIP PATCH ANTENNA AND GAIN IMPROVEMENT WITH FSS SCREENProgress In Electromagnetics Research B, 2013
- Filter-Antenna Consisting of Conical FSS Radome and Monopole AntennaIEEE Transactions on Antennas and Propagation, 2012
- ANALYSIS OF FREQUENCY SELECTIVE SURFACES FOR RADAR ABSORBING MATERIALSProgress In Electromagnetics Research B, 2012
- Frequency Selective Buildings Through Frequency Selective SurfacesIEEE Transactions on Antennas and Propagation, 2011
- Frequency-selective surfaces for GPS and DCS1800 mobile communication, Part 1: Quad-layer and single-layer FSS designIET Microwaves, Antennas & Propagation, 2007
- Frequency Selective Surfaces2000