A 28-GHz Hybrid Beamforming Transmitter With Spatial Notch Steering Enabling Concurrent Dual Data Streams for 5G MIMO Applications
- 17 May 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 59 (10) , 3378-3391
Abstract
This article presents a new notch steering scheme for hybrid beamforming transmitters (TXs) aimed at suppressing spatial interference, thereby enhancing the signal-to-interference-plus-noise ratio (SINR) to support spatial multiplexing. Built upon existing phased arrays, this scheme integrates an auxiliary-path vector modulator (VM) into each antenna element, which in turn, forms an interference-canceling beam. By spatially combining the array factors (AFs) of the main beam and the interference-canceling beam, a deep spatial notch is created while ensuring minimal main-beam power degradation. Unlike the conventional zero-forcing method that requires matrix inversion in digital for spatial notch creation, our scheme enables the computation of antenna weights in analog, significantly reducing the computational cost and latency. Leveraging this new notch steering scheme, we develop a 28-GHz four-element fully connected (FC) hybrid beamforming TX array using the GlobalFoundries 45-nm CMOS Silicon-on-Insulator (SOI) process. It is capable of simultaneously transmitting two independent, wideband data streams (DSs) in the same polarization toward two directions. In probing-based measurements, each TX channel delivers 19.7-dBm OP1 dB, 20.4-dBm $P$ SAT, and 30.6% peak power-added efficiency (PAE) at 29 GHz, demonstrating state-of-the-art TX linearity and efficiency. In over-the-air (OTA) measurements, the packaged TX array achieves 29.8-dBm EIRP1 dB and is able to steer a spatial notch outside the $-$ 10-dB beamwidth of the main beam, with a notch depth of $>$ 35 dB and a main-beam power degradation of $<$ 0.8 dB. Moreover, in spatial multiplexing demonstrations, the TX array is capable of transmitting a 400-MHz 64-quadrature amplitude modulation (QAM) signal to the intended receiver (RX) in the first DS, while suppressing the co-channel continuous-wave or wideband modulated interference created by the second DS with a high SINR.Keywords
Funding Information
- National Science Foundation (CNS-1956297)
This publication has 48 references indexed in Scilit:
- Orthogonal Versus Zero-Forced Beamforming in Multibeam Antenna Systems: Review and Challenges for Future Wireless NetworksIEEE Journal of Microwaves, 2021
- A 28GHz Hybrid-Beamforming Transmitter Array Supporting Concurrent Dual Data Steams and Spatial Notch Steering for 5G MIMO2021
- A Reconfigurable 28-/37-GHz MMSE-Adaptive Hybrid-Beamforming Receiver for Carrier Aggregation and Multi-Standard MIMO CommunicationIEEE Journal of Solid-State Circuits, 2019
- A Millimeter-Wave Polarization-Division-Duplex Transceiver Front-End With an On-Chip Multifeed Self-Interference-Canceling Antenna and an All-Passive Reconfigurable CancellerIEEE Journal of Solid-State Circuits, 2018
- A 25–30 GHz Fully-Connected Hybrid Beamforming Receiver for MIMO CommunicationIEEE Journal of Solid-State Circuits, 2018
- A Low-Cost Scalable 32-Element 28-GHz Phased Array Transceiver for 5G Communication Links Based on a $2\times 2$ Beamformer Flip-Chip Unit CellIEEE Journal of Solid-State Circuits, 2018
- A 28-GHz 32-Element TRX Phased-Array IC With Concurrent Dual-Polarized Operation and Orthogonal Phase and Gain Control for 5G CommunicationsIEEE Journal of Solid-State Circuits, 2017
- Beamspace SU-MIMO for Future Millimeter Wave Wireless CommunicationsIEEE Journal on Selected Areas in Communications, 2017
- Design of Energy- and Cost-Efficient Massive MIMO ArraysProceedings of the IEEE, 2015
- Smart antennasIEEE Antennas and Propagation Magazine, 2000