Three-Dimensional Printed Nanocomposites with Tunable Piezoresistive Response
Open Access
- 2 November 2024
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 14 (21) , 1761
Abstract
This study explores a novel approach to obtaining 3D printed strain sensors, focusing on how changing the printing conditions can produce a different piezoresistive response. Acrylonitrile butadiene styrene (ABS) filled with different weight concentrations of carbon nanotubes (CNTs) was printed in the form of dog bones via fused filament fabrication (FFF) using two different raster angles (0–90°). Scanning electron microscopy (SEM) and atomic force microscopy (AFM) in TUNA mode (TUNA-AFM) were used to study the morphological features and the electrical properties of the 3D printed samples. Tensile tests revealed that sensitivity, measured by the gauge factor (G.F.), decreased with increasing filler content for both raster angles. Notably, the 90° orientation consistently showed higher sensitivity than the 0° orientation for the same filler concentration. Creep and fatigue tests identified permanent damage through residual electrical resistance values. Additionally, a cross-shaped sensor was designed to measure two-dimensional deformations simultaneously, which is applicable in the robotic field. This sensor can monitor small and large deformations in perpendicular directions by tracking electrical resistance variations in its arms, significantly expanding its measuring range.Keywords
Funding Information
- CENTRO NAZIONALE DI RICERCA PER LA MOBILITA’ SOSTENIBILE—CNMS—CN00000023—AFFILIATO SPOKE 2—Sustainable road vehicle (POLITO) (Prot. 2022AK TCPH)
- Italian Ministry of University and Research—PRIN 2022 project “Integration of Continuous Fibers and Self-healing agents in 3D printed thermoplastic composites (INFINITE)” (Prot. 2022AK TCPH)
This publication has 75 references indexed in Scilit:
- Printing Characteristics of TPU/MWCNT Conductive Composite Using FFFInternational Journal of Precision Engineering and Manufacturing, 2024
- Properties evaluation of chemically treated TPU parts printed through FFFThe International Journal of Advanced Manufacturing Technology, 2023
- A comprehensive investigation of the 3D printing parameters’ effects on the mechanical response of polycarbonate in fused filament fabricationProgress in Additive Manufacturing, 2022
- A comparison of thermally conductive polyamide 6‐boron nitride composites produced via additive layer manufacturing and compression moldingPolymer Composites, 2021
- The effect of processing parameters on the mechanical characteristics of PLA produced by a 3D FFF printerThe International Journal of Advanced Manufacturing Technology, 2020
- Processing, mechanical characterization, and micrography of 3D-printed short carbon fiber reinforced polycarbonate polymer matrix composite materialThe International Journal of Advanced Manufacturing Technology, 2020
- Effect of the comonomer content on the solid‐state mechanical and viscoelastic properties of poly(propylene‐co‐1‐butene) filmsJournal of Applied Polymer Science, 2018
- Rapid Fabrication of Soft, Multilayered Electronics for Wearable BiomonitoringAdvanced Functional Materials, 2016
- Flexible and Stretchable Strain Sensing Actuator for Wearable Soft Robotic ApplicationsAdvanced Materials Technologies, 2016
- Electrical conductivity and thermal properties of acrylonitrile‐butadiene‐styrene filled with multiwall carbon nanotubesPolymer Engineering & Science, 2009