Phase-Duty Modulated Loop Decoupling and Design Optimization for a Triple Active Bridge Converter for Light Electric Vehicle Charging
- 3 June 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Industrial Electronics
- Vol. 4 (1) , 357-367
Abstract
This article presents a comprehensive generalized harmonics approximation based modeling and design of a triple active bridge (TAB) dc–dc converter topology aimed to facilitate simultaneous—main and auxiliary—battery charging solutions for light electric vehicle charging applications. A three-loop control scheme, incorporating the duty and phase control parameters, is proposed in this article to address the issue of inherent coupling of two output bridges and their control loops (as observed in conventional phase modulation-based voltage control techniques), along with an objective to enhance the operational efficiency of the system, in affiliation with a real-time power flow optimization algorithm. Adhering to the objective of achieving minimized losses, the optimization algorithm provides insightful design limitations in terms of selecting the required leakage inductances to ensure desired power flow at the output bridges. Furthermore, to validate the effectiveness of the proposed three-loop control, a detailed set of simulation and experimental results are presented at various steady state and dynamic load change conditions. A detailed analytical loss model of the TAB topology is also presented along with a comparative study elucidating the effectiveness of the proposed three-loop control over the conventional control schemes. The analyses portray a peak efficiency of 96.24% at the rated load of 300 W, which is 2.94% and 4.97% higher than the decoupled and the conventional phase shift control schemes, respectively.Keywords
This publication has 18 references indexed in Scilit:
- Small Signal Modeling and Decoupled Controller Design for a Triple Active Bridge Multiport DC–DC ConverterIEEE Transactions on Power Electronics, 2020
- Single-Stage Bidirectional Triple Active Bridge AC-DC converter for Single Phase Grid Applications2020
- Modelling and control of a triple‐active‐bridge converterIET Power Electronics, 2020
- Circulating and Leakage Power Flow Elimination Technique between Source Ports in Triple Active Bridge Topology2020
- Optimum Hybrid Modulation for Improvement of Efficiency Over Wide Operating Range for Triple-Phase-Shift Dual-Active-Bridge ConverterIEEE Transactions on Power Electronics, 2019
- Optimized Modulation of a Four-Port Isolated DC–DC Converter Formed by Integration of Three Dual Active Bridge Converter Stages2018
- A triple active bridge DC-DC converter capable of achieving full-range ZVS2016
- Compact Onboard Single-Phase EV Battery Charger With Novel Low-Frequency Ripple Compensator and Optimum Filter DesignIEEE Transactions on Vehicular Technology, 2015
- Multi-functional On-board Battery Charger for Plug-in Electric VehiclesIEEE Transactions on Industrial Electronics, 2014
- Power Characterization of Isolated Bidirectional Dual-Active-Bridge DC–DC Converter With Dual-Phase-Shift ControlIEEE Transactions on Power Electronics, 2012