Scattering of radio frequency waves by cylindrical density filaments in tokamak plasmas
- 1 February 2016
- journal article
- conference paper
- Published by AIP Publishing in Physics of Plasmas
- Vol. 23 (2) , 022504
Abstract
In tokamak fusion plasmas, coherent fluctuations in the form of blobs or filaments are routinely observed in the scrape-off layer. Radio frequency (RF) electromagnetic waves, excited by antenna structures placed near the wall of a tokamak, have to propagate through the scrape-off layer before reaching the core of the plasma. While the effect of fluctuations on the properties of RF waves has not been quantified experimentally, it is of interest to carry out a theoretical study to determine if fluctuations can affect the propagation characteristics of RF waves. Usually, the difference between the plasma density inside the filament and the background plasma density is sizable, the ratio of the density difference to the background density being of order one. Generally, this precludes the use of geometrical optics in determining the effect of fluctuations, since the relevant ratio has to be much less than one, typically, of the order of 10% or less. In this paper, a full-wave, analytical model is developed for the scattering of a RF plane wave by a cylindrical plasma filament. It is assumed that the plasma inside and outside the filament is cold and uniform and that the major axis of the filament is aligned along the toroidal magnetic field. The ratio of the density inside the filament to the density of the background plasma is not restricted. The theoretical framework applies to the scattering of any cold plasma wave. In order to satisfy the boundary conditions at the interface between the filament and the background plasma, the electromagnetic fields inside and outside the filament need to have the same , the wave vector parallel to the ambient magnetic field, as the incident plane wave. Consequently, in contrast to the scattering of a RF wave by a spherical blob [Ram et al., Phys. Plasmas 20, 056110-1–056110-10 (2013)], the scattering by a field-aligned filament does not broaden the spectrum. However, the filament induces side-scattering leading to surface waves and can also couple some power to the cold plasma wave different from the incident wave. The changes induced by a filament in the propagation of electron cyclotron waves and lower hybrid waves are illustrated by numerical results displaying the properties of the Poynting vector. The Poynting flux in the wake of the filament, and directed towards the core of the plasma, develops a spatial structure due to diffraction and shadowing. Thus, the fluctuations affect the uniformity of power flow into the plasma.
Keywords
Funding Information
- U.S. Department of Energy (DE-FC02-01ER54648, DE-FG02-91ER-54109, DE-FG02-99ER-54525-NSTX)
This publication has 16 references indexed in Scilit:
- Time-dependent 2-D modeling of edge plasma transport with high intermittency due to blobsPhysics of Plasmas, 2012
- Intermittent divertor filaments in the National Spherical Torus Experiment and their relation to midplane blobsNuclear Fusion, 2010
- Fokker–Planck description of the scattering of radio frequency waves at the plasma edgePhysics of Plasmas, 2010
- Saturation mechanisms for edge turbulencePhysics of Plasmas, 2009
- Edge turbulence measurements in toroidal fusion devicesPlasma Physics and Controlled Fusion, 2007
- Blob birth and transport in the tokamak edge plasma: Analysis of imaging dataPhysics of Plasmas, 2006
- Structure and motion of edge turbulence in the National Spherical Torus Experiment and Alcator C-ModPhysics of Plasmas, 2006
- Radially propagating fluctuation structures in the scrape-off layer of Alcator C-ModPhysics of Plasmas, 2006
- High-speed imaging of edge turbulence in NSTXNuclear Fusion, 2003
- On scrape off layer plasma transportPhysics Letters A, 2001